SEM in-situ investigations of the micromechanisms of damage initiation and fracture in tool steels are described. The critical state of the material and the damage growth were observed in the tests. It was shown that the initial microcracks in the steels are formed in primary carbides and then join together. A hierarchical finite element model of damage initiation, which included a macroscopic ...

The understanding of the hardenability is important in steel development with respect to weldability of steels as well as to the design of quenched and tempered steels. The common way to judge if steel is suitability to welding is the use of a carbon equivalent, which reflects the alloy content to the hardenability of the heat affected zone (HAZ). Most common of these equivalents is the IIW car...

Adding a large amount of light elements such as aluminum to steels is not a new concept recalling that several Fe-Al-Mn-C alloys were patented in 1950s for replacement of nickel or chromium in corrosion resistance steels. However, the so-called lightweight steels or low-density steels were revisited recently, which is driven by demands from the industry where steel has served as a major structu...

This work considers use neurofuzzy set theory for estimate abrasion wear resistance of steels based on chemical composition, heat treatment (austenitising temperature, quenchant and tempering temperature), hardness after hardening and different tempering temperature and volume loss of materials according to ASTM G 65-94. Testing of volume loss for the following group of materials as fuzzy data ...

A computational approach to the optimization of service properties of two-phase materials (in this case, fracture resistance of tool steels) by varying their microstructure is developed. The main points of the optimization of steels are as follows: (1) numerical simulation of crack initiation and growth in real microstructures of materials with the use of the multiphase finite elements (MPFE) a...

in this study, the four cr-mn-(ni-free) austenitic steels were fabricated by vacuum induction furnace. then plates with 10 mm thickness were fabricated by hot-rolling. corrosion behaviour of the four cr-mn steels in 0.1 m h2so4 solution was investigated using by open-circuit potential, potentiodynamic polarization, and electrochemical impedance spectroscopy (eis). the results indicated that the...

Lightweight advanced high strength steels (AHSS) with aluminum contents between 4 and 12 weight percent have been the subject of intense interest in the last decade because of an excellent combination of high strain rate toughness coupled with up to a 17% reduction in density. Fully austenitic cast steels with a nominal composition of Fe-30%Mn-9%Al-0.9%C are almost 15% less dense than quenched ...

interstial free steels have good formability and also excellent deep drawability. these features make them one of the applicable materials in automotive industry. chemical composition and thermomechanical treatment used to process these steels have important role in final properties of them. in this study, the effect of chemical compositon on texture, anisotropical properties and bake hardenabi...

The unique properties of air-cooled bainitic steels have been described. A series of Mn containing air-cooled bainitic steels invented by authors is presented in this paper: including low carbon granular bainitic steels, low carbon grain-boundary allotriomorphic ferrite/granular bainite duplex steels, medium and medium high carbon bainite/martensite duplex steel, and low carbon carbide free bai...