Abstract: Four-switch synchronous buck-boost (FSBB) converter is much suitable for battery management system for its characteristic of wide input voltage range, high efficiency, and positive voltage output. A three mode control scheme with two modulation signals and one carrier can be adopted to achieve the smooth transition among modes. Using feed forward voltage mode control, the input voltag...

in this paper, we investigated the necessity and effects of optimal control methods in the stability and performance of a micro-grid that operates in islanded mode. the micro-gird is consisted of a combine heat and power (chp), a capacitor bank (cb), photovoltaic panel (pv) as power generation sources. in addition, battery and the building electricity and thermal load are placed on the load sid...

This paper proposes a pulsed power generator which consists of two types of switched-capacitor booster modules. A doubling mode module employed to elevate the input voltage to a specified level and, constant mode module is used to increase the elevated voltage into the finally intended bipolar output voltage. Also, the proposed modular structure does not utilize any switches across the load. Ot...

This paper proposes the grid synchronization method of inverter using a quasi Proportional+Multi Resonant (P+MR) control-based voltage controller a stationary reference frame. The inverter supplies a non-linear load under the islanded mode. In islanded mode, the inverter is defined as a voltage source to supply the full local load demand without a connection to the grid. On the other hand, if t...

This paper proposes an improved control method based on modified Delta-Sigma Modulator (DSM) to enhance transient response and improve harmonic contents of buck DC-DC converter. The main advantages of the proposed method are improving the output voltage frequency spectrum, correction of the output voltage harmonic contents and sideband harmonics, reduction of switching noise peaks at the output...

Improving transient voltage stability is one of the most important issues that must be provided by doubly fed induction generator (DFIG)-based wind farms (WFs) according to the grid code requirement. This paper proposes adjusted DC-link chopper based passive voltage compensator and modified transient voltage controller (MTVC) based active voltage compensator for improving transient voltage stab...

In this paper, a novel approach for two-loop control of the DC-DC Ćuk converter in discontinuousconduction mode is presented using a sliding mode controller. The proposed controller can regulatethe output of the converter in a wide range of input voltage and load resistance. Controllerparameters are selected using PSO algorithms. In order to verify the accuracy and efficiency of thedeveloped sl...

this paper proposes a low voltage (±0.55v supply voltage) low power (44.65µw) high common mode rejection ratio (cmrr) differential amplifier (d.a.) with rail to rail input common mode range (icmr), constant transconductance (gm) and enhanced frequency performance. its high performance is obtained using a simple negative averaging method so that it cancels out the common mode input signals at th...

Abslrad : Some practical methods --r implementing the sliding-mode control law to control the buck-type converters are introduced. The control equations are derived from the basic slidmg-mode control law to accommodate the conventional fiied-frequency pwm control method. As a result, the overall feedback control systems can be expressed under a form similar to state-feedback control where the v...