Hot-melt extrusion is one of the most widely applied processing technologies in the plastic, rubber and food industry. Today this technology has found its place in the array of pharmaceutical manufacturing operations. Melt extrusion process are currently applied in the pharmaceutical field for the manufacture of a variety of dosage forms and formulations such as granules, pellets, tablets, supp...

This paper is about experimental results for partial reduction of vortex at vertical pipe intakes. One of the easiest and practical ways of reducing vortex effect is to use anti-vortex plates or baffles. These plates can be used to avoid the vortex completely or partially. This paper will concentrate on the latter case. Rectangular plates with different dimensions have been placed at different ...

Fabrication of highly dense parts with complex geometry by paste-extrusion-based solid freeform fabrication processes requires a precise control of the extrusion flow rate to dispense material on demand, which is often referred as Extrusion-On-Demand (EOD). The extrusion process for aqueous ceramic pastes is complex and difficult to control due to their non-Newtonian behavior, compressibility a...

This article reviews the infrequently utilized treatment method of forced eruption and how it can serve as an alternative to the sacrifice of the natural root system. Forced eruption can preserve the natural root system and related periodontal architecture, resulting in years of additional service for the patient. It also can maintain adjacent tooth structure while retaining the option for futu...

one of the most important parts of power transmission in automotives is c.v. joint, which consists of four components where exterior bowl is one of them. due to its complexity, and importance in automobile and existence of high stresses, forging process is the only cost effective method of production. hence, the best method of production of this part is forging process. the exterior part of c.v...

Introduction Bar extrusion is a process in which a block of metal (billet) is forced to flow by compression through a tool (die) opening of a smaller crosssectional area than that of the original billet. There are two basic types of bar extrusion: direct and indirect. The most important and common method used is the direct extrusion (Lange 1988). Figure 1 shows the principle of direct bar extru...

In this study, five microcrystalline cellulose (MCC) grades were physically characterized and their extrusion-spheronization behaviours were characterized in terms of water requirements and pellet shape profiles. It was found that the MCC grades differed significantly in the physical properties investigated. Physical properties of MCC were found to influence the water requirement for extrusion-...

The ZK61 alloy rods with different grain sizes and crystallographic texture were successfully fabricated by cyclic extrusion and compression (CEC). Their room-temperature tension & compression yield strength displayed a significant dependence on grain size and texture, essentially attributed to {10-12} twinning. The texture variations were characterized by the angle θ between the c-axis of ...