Nanofluids are solutions of a small fraction of suspended nanoparticles in a bulk fluid. Nanofluids have shown great promise as heat transfer fluids over typically used bulk fluids and fluids with micron sized particles. The nanoparticles do not settle in the fluid and do not cause clogging or damage to surfaces as with micron sized particles. In the current work we compare the performance of d...

The objective of this study is to numerically investigate the convective heat transfer of water-based Al2O3 nanofluids flowing through a square cross-section duct with a constant heat flux under laminar flow conditions. The effects of nanoparticle concentration and Peclet number on the heat transfer characteristics of Al2O3-water nanofluids are investigated. The nanoparticle diameter is 25 nm a...

an empirical electrical conductivity assessment of nanofluids comprising cuo nanoparticles water-based in different concentrations, particles size and various temperatures of nanofluids has been carried out in this paper. these experimentations have been done in deionized water with nanoparticles sizes such as 89, 95, 100 and 112 nm and concentrations of 0.12 g/l, 0.14 g/l, 0.16 g/l and 0.18 g/...

for better understanding the effect of nanofluid flow in a porous medium, a set of experiments were conducted on a horizontal glass micromodel for al2o3-water nanofluids. to characterize the flow of nanofluids the same experiment was done by pure water. the glass micromodel was constructed by a photolithography technique. the al2o3-water nanofluids were produced by a two-step method and no surf...

In the present study, stable homogeneous graphene nanoplatelet (GNP) nanofluids were prepared without any surfactant by high-power ultrasonic (probe) dispersion of GNPs in distilled water. The concentrations of nanofluids were maintained at 0.025, 0.05, 0.075, and 0.1 wt.% for three different specific surface areas of 300, 500, and 750 m2/g. Transmission electron microscopy image shows that the...

The purpose of this experimental study is to evaluate the effects of particle species, surface charge, concentration, preparation technique, and base fluid on thermal transport capability of nanoparticle suspensions (nanofluids). The surface charge was varied by changing the pH value of the fluids. The alumina (Al2O3) and copper oxide (CuO) nanoparticles were dispersed in deionized (DI) water a...

Nanofluids are engineered colloidal suspensions of nanoparticles in water, and exhibit a very significant enhancement (up to 200%) of the boiling Critical Heat Flux (CHF) at modest nanoparticle concentrations (50.1% by volume). Since CHF is the upper limit of nucleate boiling, such enhancement offers the potential for major performance improvement in many practical applications that use nucleat...

The tribological behaviors of graphene and graphene oxide (GO) as water-based lubricant additives were evaluated by use of a reciprocating ball-on-plate tribometer for magnesium alloy-steel contacts. Three sets of test conditions were examined to investigate the effect of concentration, the capacity of carrying load and the endurance of the lubrication film, respectively. The results showed tha...

Nanofluids, colloidal suspensions consisting of base fluids and nanoparticles, are a new generation of engineering working fluids. Nanofluids have shown great potential in heat/mass transfer applications. However, their practical applications are limited by the high production cost and low stability. In this study, a low-cost agricultural waste, rice husk ash (RHA), was used as a silicon source...

A theoretical analysis has been made to explore thermal entrance region heat transfer in nanofluids. The numerical model used in this paper is based on the Buongiorno model for convective heat transfer in nanofluids with modifications to fully account for the effects of nanoparticles volume fraction distributions on the continuity, momentum and energy equations. Numerical investigations have be...