functionally graded aluminium/zirconia metal matrix composite was fabricated using stir casting technique followed by horizontal centrifugal casting process and a hollow cylindrical functionally graded composite (150 x 150 x 16 mm) was obtained with centrifuging speed of 1200 rpm. the microstructural evaluation and hardness test was carried out on the outer and inner surface of the functionally...

The following paper will describe a methodology for automatically detecting and diagnosing rolling element bearing wear. The techniques involved have been proven in over 15 years of use in a huge variety of environments, machine types and applications. The techniques involved in diagnosing bearing wear will be described in detail and supported by a set of example graphs and an annotated diagnos...

nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. in this paper, ultrasonic assisted turning (uat) isperformed to create the micro textures on the flat faces. micro surface texturing ismade on the al7075-t6 by the uat in the face turning process. then, the influences of cutting speed feed, vibration direction and vibration ampl...

The significant costs insert on mineral processes due to mill liner wear including the labor costs, price of material and shut down periods. Therefore, the study of this phenomenon is economically important to optimize the mill operating conditions and liner profile design to decrease the wear rate. There is no appropriate and applicable research on impact wear evaluation of mill liners. In the...

In this study, small fraction of NiTi (5 wt%) was added to Yttria stabilized zirconia (YSZ) top coat to improve it sliding wear resistance. The measurement of width of wear tracks after wear tests under a 15 N load for 100 m sliding distances showed that the width of wear track in NiTi-YSZ coating is shorter than that in YSZ coating which depicts the higher wear resistance of NiTi-YSZ coa...

ni-w coatings, compared to pure nanocrystalline ni, exhibit higher hardness and wear resistance. in some cases, these coatings are considered as environmental friendly alternatives for hard chromium coating. till now, most of ni-w coatings have been produced by direct current electrodeposition from alkaline baths. in this study square pulse current was used for deposition of ni-w precipitates f...

wear is a complicated phenomenon caused by the relative movement of two contacting surfaces compressed together by a normal force. prediction of the wear, in most cases, requires various experiments and microstructural characterization of the contacting surfaces. mathematical models based on physical concepts could provide considerable help in understanding the physical behavior and hence the p...

A new wear testing system, which carries out toothbrush wear and simulated occlusal wear tests alternately, was developed. Differences in wear behavior among three modes of wears, combined wear, toothbrush wear and simulated occlusal wear, were investigated using polymethylmethacrylate (PMMA) and two commercial resin composites (Z100, APX). The area of the material loss after each test was meas...

the aim of this research was to study the wear behavior of 42crmo4 steel/zro2 composite with 10 and 30 ppi performed ceramic and compare it with the un-reinforced steel under different applied loads. the composite specimens were obtained by pressureless infiltration of the melt into a preformed ceramic of zirconium oxide. the effect of applied load on the specimens wear behavior was studied by ...