Eroded enamel is more susceptible to abrasive wear than sound enamel. New toothpastes utilizing diamond particles as abrasives have been developed. The present study investigated the abrasive wear of eroded enamel by three commercially available toothpastes (one containing diamond particles) and compared it to the respective wear of sound enamel caused by these toothpastes. Seventy-two bovine e...

Particles larger than a component's internal clearances are not necessarily dangerous. Particles the same size as the internal clearance cause damage through friction. But the most dangerous particles in the long-term are those that are smaller than the component's internal clearances. Particles smaller than 5 microns are highly abrasive. If present in sufficient quantities, these invisible 'si...

Being subjected to a high-pressure abrasive water jet, solid samples will experience an essential variation of both internal stress and physical characteristics, which is closely associated with the kinetic energy attached to the abrasive particles involved in the jet stream. Here, experiments were performed, with particular emphasis being placed on the kinetic energy attenuation and turbulent ...

The paper discusses the material removal process in refractory ceramics eroded by hydro-abrasive jets. In particular, bauxite, sintered magnesia, and magnesia chromite are eroded. The influence of abrasive particle velocity, local exposure time, abrasive mass-flow rate, and abrasive type is investigated. Erosion depth, specific erosion rate, and geometry of the generated cavities are measured a...

Wear maps were developed following a series of micro-abrasion-corrosion testing during idealised hip contact conditions for a CoCrMo alloy in a foetal calf serum solution. The main aim of the study was to characterise wear-corrosion or bio-tribocorrosion regimes of the alloy over a range of applied loads and applied potentials. The transitioning micro-abrasion-corrosion mechanisms, synergisms a...

The increasing use of high-pressure water jets in the industry for machining materials yields numerous studies aiming at the optimization of this technology. Since the experimental study of pure or abrasive water jet cutting is complex to carry out, the numerical simulation of this process stands as an attractive alternative. Such a simulation relies on the coupling of numerical tools devoted o...

Limited efforts have been done towards enhancing the productivity of Abrasive Flow Machining (AFM) process with regard to better quality of work piece surface. In recent years, hybrid-machining processes have been developed to improve the efficiency of a process by clubbing the advantages of different machining processes and avoiding limitations. In the present study, the abrasive flow machinin...

The process monitoring and mechanics of fixed abrasive diamond wire saw machining are investigated in this study. New techniques to affix diamond particles to a steel wire core have advanced to make this process feasible for the machining of ceramics, wood, and foam materials. Developments in fixed abrasive diamond wire machining are first reviewed. Advantages of using fixed abrasive diamond wi...

INTRODUCTION Interactions of the ceria particles with polyurethane surfaces are of great interest for polishing processes used in modern semiconductor industry. Specifically, ceria abrasive nanoparticles and polyurethane polishing pads are now broadly used in the process called Chemical-Mechanical Planarization/Polishing (CMP) [1,2,3]. To optimize the process of CMP, various chemicals, abrasive...