in the polymer electrolyte membrane fuel cells (pemfcs), low corrosion resistance and high interfacial contact resistance (icr) are two controversial issues in usage of aisi 316l stainless steel as a metallic bipolar plate. for solving these problems, investigation and development of different coatings and/or surface treatments are inevitable. corrosion behavior and icr of aisi 316l specimens c...

Initiation of corrosion on reinforcing bars occurs when a critical chloride concentration is achieved. A universal value for the chloride concentration that causes depassivation has not been agreed upon for carbon steels due to a variety of experimental factors. The chloride threshold depends on the rebar material, rebar surface condition, testing environment, method of detection, definition of...

This article describes the susceptibility of 316L stainless steel to stress corrosion cracking (SCC) in a nitrite-containing chloride solution. Slow strain rate testing (SSRT) in 30 wt. % MgCl₂ solution established SCC susceptibility, as evidenced by post-SSRT fractography. Addition of nitrite to the chloride solution, which is reported to have inhibitive influence on corrosion of stainless ste...

In this paper, application of ultrasonic techniques for defect detection in weldments of austenitic stainless steel and maraging steel is discussed. Applications of ultrasonic techniques for characterizing microstructural changes in AISI type 316 stainless steel and modified 9Cr-1Mo ferritic steel; thermomechanical processing of 15Cr-15Ni-2.3Mo-titanium modified austenitic stainless steel (allo...

This article presents corrosion data and microstructural analysis data of austenitic stainless steels AISI 316L and AISI 347H exposed to supercritical water (25 MPa, 550 °C) with 2000 ppb of dissolved oxygen. The corrosion tests lasted a total of 1200 h but were interrupted at 600 h to allow measurements to be made. The microstructural data have been collected in the grain interior and at grain...

A contactless temperature measurement system is presented based on a hyperspectral line camera that captures the spectra in the visible and near infrared (VNIR) region of a large set of closely spaced points. The measured spectra are used in a nonlinear least squares optimization routine to calculate a one-dimensional temperature profile with high spatial resolution. Measurements of a liquid me...

in recent years, more attention is paid to stainless steel 316l as fracture plate and fixation in human's body. present studies are focused on surface and metallurgical properties of this material. biocompatibelity of this material and its superior mechanical properties has made it the most demanded biomaterial. in this research, four different implants are investigated in three stages. four co...

INTRODUCTION Contaminated sponges might lead to cross-contamination in kitchens since they can transfer microorganisms to surfaces where microorganisms can survive for hours or days and contaminate food. The main objective of this study was to evaluate the transfer and the survival of bacteria from kitchen sponges to surfaces of AISI 316 stainless steel and polyethylene. METHODOLOGY Twenty-fo...

The enormous demands for metal implant have given rise to a search for cheap material with good bio-tolerability and resistance to corrosion. Although stainless steel has these properties and is widely used for this purpose, its long term application is still a concern. The corrosion resistance of stainless steel depends on the passive layer. Herein, chemical surface treatment, including passiv...