An overview of systematic studies that address the complexity of nanofluid systems and advance the understanding of nanoscale contributions to viscosity, thermal conductivity, and cooling efficiency of nanofluids is presented. A nanoparticle suspension is considered as a three-phase system including the solid phase (nanoparticles), the liquid phase (fluid media), and the interfacial phase, whic...

Convective heat transfer can be enhanced by changing flow geometry and/or by enhancing thermal conductivity of the fluid. This study proposes simultaneous passive heat transfer enhancement by combining the geometry effect utilizing nanofluids inflow in coils. The two nanofluid suspensions examined in this study are: water-Al2O3 and water-CuO. The flow behavior and heat transfer performance of t...

Heat transfer improvement in circular pipe by using nanofluid and twisted tape is presented in this review paper. Experimental and numerical studies are incorporated involving both the range of turbulent and laminar flow. Effect of type and volume fraction of nanofluid on performance of heat transfer was referred along with the length and twist ratio of the tape through the pipe on heat transfe...

Experimental investigations of heat transfer coefficient of CuO/Water nanofluid are reported in this paper. The heat transfer coefficient of the CuO/water was measured with the help of double pipe heat exchanger. The nanofluid was prepared by dispersing a CuOnano particle in deionized water. CuO/water nanofluid with a nominal diameter of 27nm at different volume concentrations (0.1 &0.3 vol.%) ...

This study analyzes the characteristics of alumina (Al2O3)/water nanofluid to determine the feasibility of its application in an air-cooled heat exchanger for heat dissipation for PEMFC or electronic chip cooling. The experimental sample was Al2O3/water nanofluid produced by the direct synthesis method at three different concentrations (0.5, 1.0, and 1.5 wt.%). The experiments in this study mea...

This article mainly concerns theoretical research on entropy generation influences due to heat transfer and flow in nanofluid suspensions. A conventional nanofluid of alumina-water (Al2O3-H2O) was considered as the fluid model. Due to the sensitivity of entropy to duct diameter, miniand microchannels with diameters of 3 mm and 0.05 mm were considered, and a laminar flow regime was assumed. The ...

It is necessary to control the temperature of solar cells for enhancing efficiency with increasing concentrations of multiple photovoltaic systems. A heterogeneous two-phase model was established after considering the interacting between temperature, viscosity, the flow of nanofluid, and the motion of nanoparticles in the nanofluid, in order to study the microchannel heat sink (MCHS) using Al2O...

Numerical simulation and experimental investigation were used for study of laminar forced convective heat transfer of Al2O3/water nanofluid. Single phase model with temperaturedependent properties was employed for numerical simulation of transport phenomena in nanofluid. The results of experiments and computer-aided simulation indicated remarkable enhancement of convective heat transfer of base...

In this work, a Homotopy Perturbation Solution of magnetohydrodynamic (MHD) model of boundary-layer equations for an electrically conducting Nanofluid flow bounded by an infinite parallel vertical permeable plates is to be introduced. This model is applied to study the mass and heat transfer of an unsteady nanofluid, incompressible flow with suction, internal heat generation, Hall Effect and Ch...

a Young Researchers Club, Kermanshah Branch, Islamic Azad University, Kermanshah, Iran b Department of Mechanical Engineering, University of British Columbia Vancouver, Canada Forced convection boundary layer magneto-hydrodynamic (MHD) flow of a nanofluid over a permeable stretching plate is studied in this paper. The effects of suction-injection and viscous dissi 1 pation are taken into accoun...