Hydraulic jumps formed in closed rectangular sloping conduits aree investigated experimentally. Both positive and negative slopes are considered. The results are analyzed in terms of the inlet Froude number, the bottom slope and the inflow depth ratio. The experiments are conducted in a laboratory flume. Nineteen models are tested. Ten model for positive slope and another ten models nine negati...

Hyalite Reservoir, bntana, was studied to determine properties of this small, montane, headwater, deep-release reservoir relative to reservoirs at lower elevations. While retention times for waters were as brief as 12 d, the mean residency of 40 d from mid-March to mid-December was within the range reported for other reservoirs. No significant through-reservoir gradients for suspended sediments...

Effect of configuration (structure of electrode, interelectrode gap, positions of inlet and outlet, volume of the cell and additional nets) on mass transfer characteristic of a filter-press type electrochemical cell has been studied. The mass transfer coefficients on the electrodes were obtained by using the well-known technique based on the determination of limiting diffusion current. It is fo...

this paper presents results of a numerical study of mixed convection and entropy generation of cu–water nanofluid in a square ventilating cavity at different inclination angles. except a piece of bottom wall with a uniform heat flux, all of the cavity walls are insulated. the inlet port is placed at the bottom of the left wall and the outlet port is positioned at the top of the right wall. entr...

We present experimental results obtained with a two-dimensional silo discharging under gravity through an orifice at the flat bottom. High-speed measurements provide enough time resolution to detect every single bead that goes out and this allows the measurement of the flow rate in short-time windows. Two different regimes are clearly distinguished: one for large orifices, which can be describe...

A three-dimensional computational fluid dynamics (CFD) model was used to calculate the velocity distribution among multiple parallel microchannels with triangle manifolds. The influences of structural parameters on velocity distribution among microchannels were analyzed. The simulation results showed that the velocity distribution became more uniform with larger microchannel length, depth or sm...

As continental ice from Antarctica reaches the grounding line and begins to float, its underside melts into the ocean. Results obtained with satellite radar interferometry reveal that bottom melt rates experienced by large outlet glaciers near their grounding lines are far higher than generally assumed. The melting rate is positively correlated with thermal forcing, increasing by 1 meter per ye...

During floods, sediments are transported from watersheds into reservoirs, slowly decreasing water volumes and this leading to economic losses. Thus, in the long term, sedimentation endangers reservoirs’ sustainability. Sediments can also block low-level hydraulic structures such as bottom outlets and powerhouse intakes and cause abrasion of gates and turbines. Additionally, the trapped sediment...

Abstract In order to study the effect of near-ground explosion energetic materials (EMs) on shell a vertical incinerator, different heights EMs 90 g TNT incinerator with exhaust gas outlet diameters was numerically simulated in three dimensions using AUTODYN software. The simulation results showed that maximum von Mises equivalent stress (mis. stress) occurred at upper edge outlet. Furthermore,...