Cr-Fe-C alloy deposits were successfully prepared on high-carbon tool steel in a Cr3+-based electroplating bath containing Fe2+ ions and suitable complex agents. A Cr-based alloy deposit was obtained with an electroplating current density higher than 25 Adm-2, and a Fe-based alloy deposit was obtained using a current density of 20 Adm-2. Following electroplating, these alloy deposited specimens...

Abstract In order to understand the effect of high temperature pre-precipitation (HTPP) on precipitation behavior and tensile properties A356.2 alloy treated by Al-6Sr-7La master alloy, SEM, TEM tests were applied investigate evolution fracture morphology precipitates alloys under different HTPP temperatures. The results showed that ultimate strength (UTS) yield (YS) decrease elongation (El) in...

In vitro tensile bond strengths were determined for three adhesive cements and two resin-bonded bridge cements to two alloys, each prepared by two methods: sandblasted Ni-Cr-Be alloy (I), electro-etched Ni-Cr-Be alloy (II), sandblasted Type IV gold alloy (III), and tin-plated Type IV gold alloy (IV). Storage conditions of 24 hours at 37 degrees C and 30 days at 70 degrees C were evaluated. The ...

The paper presents the results of studies on the effect of the AlSi17Cu5 alloy overheating to atemperature of 920°C and modification with phosphorus (CuP10) on the resultingmechanical (HB, Rm, R0.2) and plastic (A5 and Z) properties. It has been shown that, so-called, "timethermal treatment" (TTT) of an alloy in the liquid state, consisting inoverheating the metal to about 250°C above T liq,hol...

An Aluminum based in-situ alloy reinforced with Mg2Si and Si hard particles produced by casting Al-6Si-0.5Mg alloy. The microstructure, tensile properties and fracture behavior of the alloy were investigated and the results show that the Mg2Si and Si hard particles produced by precipitation hardening have great effects. The homogenized (24hr at 500 o C) and solutionized (2hr at 540 o C) cast al...

One of the greatest environmental goals for aluminum alloys industry is generating higher quality products by introducing cleaner input materials while maintaining low production costs. A typical dilemma master alloy producers cleanness level since insoluble inclusions could serve as inoculants during solidification process. In this work, commercial Ti5B1 used grain refinement Al7Si4Cu and comp...

Over the years, aluminum content in a vehicle part is increasing due to the needs to reduce weight as well as increase fuel efficiency. Most of the cast product in a vehicle part is mostly cast from A356 alloy. It is used because A356 alloy posses’excellent characteristics over other type of alloy such as cast ability, high weight-to-strength ratio, good corrosion resistance and good weld-abili...

In this paper, the fractal dimensions are proposed for characterizing the optical fiber corrosion sensors, which is applied to measure the steel corrosion based on Fe-C alloy film. Because corrosion was a complex random phenomenon and the corrosion surface of Fe-C alloy film of the optical fiber corrosion sensor possessed fractal characteristics, the image fractal dimensions is as a quantitativ...