Mann, David William: 90nm CMOS Driver Amplifier for WCDMA Mobile Applications (Under the direction of Dr. Kevin Gard.) Integration is driving today’s cellular phone industry to create single chip cellphone systems. With the integration of Radio Frequency Transmitters into CMOS technology, robust circuits are needed that can scale with new technologies. This thesis explores the challenges of des...

A power amplifier (PA) is a key part of the RF front-end in transmitters for a local broadband network. Today, commercial PAs are made of III-V HEMT and HBT technology with excellent results. An integrated system-on-chip power amplifier circuit using CMOS technology for cost-effective and spectrum-efficient high-speed wireless communication presents major challenges because power amplifiers hav...

A CMOS broadband amplifier with high-Q active inductor using 0.25um CMOS process is presented. In this broadband amplifier, the compact high-Q active inductor is connected to the common-gate configuration to improve the performance of the high power gain, wide bandwidth, low power consumption and simple matching characteristics. Not using any passive inductor components is to be reduced the are...

In this work a low power, low voltage and high gain operational amplifier is proposed. For this purpose a negative resistance structure is used in parallel with output to improve the achievable gain. Because of using self cascode transistors in the output, the proposed structure remains approximately constant in a relatively large output voltage swing causing an invariable gain. To evaluate the...

In this paper, power amplifier operating with center frequency of 947.5 MHz, which can be used for the transmitter in beamforming systems, is proposed. The power amplifier implemented provides high power added efficiency (PAE) of 71.967% and low noise figure (NF) as low as 1.525. The linearity of the power amplifier is improved by using square law and cubic law analog predistortion techniques. ...

A low-noise CMOS amplifier operating at a 1-V supply voltage is developed using the two noise reduction techniques of autozeroing and chopper stabilization. The proposed amplifier utilizes a feedback with virtual grounded input-switches and a multiple-output switched op-amp. The low-noise amplifier fabricated by a 0.18-μm CMOS technology was measured at a 1-V power supply, and achieved low nois...

In this study an ultra-broad band, low-power, and high-gain CMOS Distributed Amplifier (CMOS-DA) utilizing a new gain-cell based on the inductively peaking cascaded structure is presented. It is created bycascading of inductively coupled common-source (CS) stage and Regulated Cascode Configuration (RGC).The proposed three-stage DA is simulated in 0.13 μm CMOS process. It achieves flat and high ...

1. Abstract This paper presents the features of Instrumentation Amplifier for biomedical applications. This Instrumentation Amplifier is a device created from Operational Tran conductance Amplifier. It is designed to have input high impedance , output low impedance, low DC offset, low noise , high common mode rejection ratio and high power supply rejection ratio. The circuit has been integrated...