The cylinder working fluid mean temperature, rate of heat fluxes to combustion chamber and temperature distribution on combustion chamber surface will be calculated in this research. By simulating thermodynamic cycle of engine, temperature distribution of combustion chamber will be calculated by the Crank-Nicolson method. An implicit finite difference method was used in this code. Special treat...

Nanocrystalline complex oxides have been synthesized by combination of sol–gel auto combustion and ultrasonic irradiation techniques using copper nitrate, zinc nitrate as metallic nitrates and glycine, urea and thiourea as fuels. Sol-gel combustion (combination of the chemical sol–gel process and the combustion process) as a proper synthesized technique is used to synthesize ZnO/CuO nanocomposi...

Combustion is a natural phenomenon. It happens in forest, automotive engine and gas cooker. In Computational Fluid Dynamics (CFD), the combustion phenomenon complies with a set of partial differential equations. According to the resolution scale, from big to small, the simulation methods in combustion are Reynolds Averaged Navior Stokes method (RANS), Large Eddy Simulation (LES), and Direct Num...

There are many incentives to increase the fuel efficiency of combustion processes. This paper looks at two available options to achieve this goal. The former aims to develop an experimental method that can analyze combustion at extremely high pressures to improve the understanding of high pressure H2/air combustion. Experimental data has been lacking a suitable combustion diagnostic to visualiz...

This paper considers an approach to design a controller used for the air-to-fuel ratio (AFR) optimization in the combustion process of a power plant boiler. The optimization of the AFR will reduce the excess air level and improve the combustion efficiency in the boiler system. The combustion improvement indicates boiler operating cost savings. The fuzzy logic controller, which is a method of a ...

The purpose of this paper is to investigate combustion characteristics for rotary engine via numerical studies. A 3D numerical model was developed to study the influence of several operative parameters on combustion characteristics. A novel rotary engine called, “Leaf Spring Rotary Engine”, was used to illustrate the structure and principle of the engine. The aims are to (1) improve the underst...

Much energy is lost through excess air flow in and out of process heating equipment. Energy saving opportunities from managing air flow include minimizing combustion air, preheating combustion air, minimizing ventilation air, and reconfiguring openings to reduce leakage. This paper identifies these opportunities and presents methods to quantify potential energy savings from implementing these e...

Magnetic powder of Sr-ferrite was prepared by conventional and sol-gel auto-combustion methods. In conventional method, strontium carbonate and ferric oxide powders were mixed together and then mixture was calcined. In sol-gel auto-combustion method, a solution containing strontium nitrate, ferric nitrate and citric acid was heated until the combustion took place automatically; then, as-burnt p...

Combustion behavior (swelling during combustion and combustion time) of the kraft black liquors varies significantly between pulp mills and also time-dependent variations within a mill occur. In addition, due to the different raw materials and pulping conditions, some further variations in these combustion properties are typically observed. Therefore, by means of the proper process control and ...

Combustion instabilities in gas turbine has been a major setback in the quest for efficient and clean combustion. Accurate characterisation and prediction of these disturbances is required to suppress them either at the design stage or in a close loop control when the system is in operation. The use of flame transfer functions has been a common approach in different literatures. Flame temperatu...