We examine a simple, fuel-air, model of combustion in spark ignition (si) engine with indirect injection. In our two fluid model, variations of fuel mass burned in cycle sequences appear due to stochastic fluctuations of a fuel feed amount. We have shown that a small amplitude of these fluctuations affects considerably the stability of a combustion process strongly depending on the quality of a...

The numerical modelling and process simulation for the fault diagnosis of rotary kiln incinerator were accomplished. In the numerical modelling, two models applied to the modelling within the kiln are the combustion chamber model including the mass and energy balance equations for two combustion chambers and 3D thermal model. The combustion chamber model predicts temperature within the kiln, fl...

CFD analysis on the MSW incinerator combustion chamber provides crucial insight on the thermal flow fields, but a difficulty arise from the boundary conditions on the waste bed in which the combustion is governed by complicated heat and mass transfer phenomena. Solid waste bed combustion models are constructed to predict the combustion process and corresponding generation of gas phase species b...

Membrane gas separation for carbon capture has traditionally been focused on high pressure applications, such as pre-combustion capture and natural gas sweetening. Recently a membrane-cryogenic combined process has been shown to be cost competitive for post-combustion capture from coal fired power stations. Here, the membrane-cryogenic combined process is investigated for application to post-co...

This work is carried out to investigate combustion characteristics of a dual fuel (diesel-gas) engine at part loads, using a quasi-dimensional multi zone combustion model (MZCM) for the combustion of diesel fuel and a single zone model with detailed chemical kinetics for the combustion of natural gas fuel. Chemical kinetic mechanisms consist of 184 reactions with 50 species. This combustion mod...

The dual fuel engines at part loads inevitably suffer from lower thermal efficiency and higher carbon monoxide and unburned fuel emission. This work is carried out to investigate combustion characteristics of a dual fuel (dieselgas) engine at part loads, using a single zone combustion model with detailed chemical kinetics for combustion of natural gas fuel. The authors developed software in ...

Ways to reduce nitrogen oxide emissions In order to comply with the increasingly tough emission standards worldwide, engine manufacturers are forced not only to substantially reduce emissions of particulate matter (PM), but also emissions of nitrogen oxides. The main approach pursued by MTU is low-emission combustion, in other words an internal engine solution. However, this means taking into a...

We analyse the combustion process in a spark ignition engine using the experimental data of an internal pressure during the combustion process and show that the system can be driven to chaotic behaviour. Our conclusion is based on the observation of unperiodicity in the time series, suitable stroboscopic maps and a complex structure of a reconstructed strange attractor. This analysis can explai...

In order to comply with the increasingly tough emission standards worldwide, engine manufacturers are forced not only to substantially reduce emissions of particulate matter (PM), but also emissions of nitrogen oxides. The main approach pursued by MTU is low-emission combustion, in other words an internal engine solution. However, this means taking into account a basic principle that governs th...

The thermal characteristics and kinetics of coal, biomass (pine sawdust) and their blends were evaluated under combustion conditions using a non-isothermal thermogravimetric method (TGA). Biomass was blended with coal in the range of 5-80 wt.% to evaluate their co-combustion behaviour. No significant interactions were detected between the coal and biomass, since no deviations from their expecte...