Mathematical models have been popularly applied to study the compression processes of superheated refrigerant vapor in compressors. As to the case when refrigerant enters a compressor cylinder in the state of liquid and vapor mixture, however, the availability of fundamental studies is very limited. -A mathematical model is presented to simulate the compression processes of two-phase saturated ...

Compressor performance is ioiluenced by many factors. Besides the commonly considered factors such as suction gas heating, leakage, compressed gas re-expansion, gas pulsations, and back flow, supercharging effect on performance is also studied. Since the compressor used in this study operates in a wide speed range, from 1100 rpm up to 9000 rpm, how those factors affect the compressor performanc...

the noise profile. In order to locate the various sources of noise of the hermetic rolling position type compressor for room air conditioners, we experimentally analyzed the compressor noise and found that a main cause of the·noise was the acoustically amplified pressure pulsation in various parts of the compressor. Moreover, with reference to results of this noise source analysis, several proc...

The energy efficiency of separate sensible and latent cooling (SSLC) airconditioning system is higher than traditional one, since SSLC system uses separate cycles which can raise the evaporating temperature of sensible cycle. Separate cycles often include two separate compressors, which makes the initial investment of SSLC cycle too expensive to use in room air conditioning. A novel structure r...

An experimental rig has been built to test a horizontal scroll compressor and a reciprocating compressor of similar size and capacity. The compressors were tested with refrigerant.R404A operating at varying evaporator and condenser temperatures. The paper provides much needed information regarding the efficiency of the compressors operating under the same conditions with the same system paramet...

During hot seasons the inlet temperature of Nitrogen increases, as a result compressor consumes more power for compressing a specific mass ratio of fluid and consequently total energy consumption of the compressor increases as well. In this research, a three stage centrifugal compressor with intercooler was modeled thermodynamically in order to decreases the energy consumption of the compressor...

Previous work on stabilization of compressor surge is extended to include control of the angular velocity of the compressor. First a low-order centrifugal compressor model is presented where the states are mass flow, pressure rise, and rotational speed of the spool. Energy transfer considerations are used to develop a compressor characteristic. In order to stabilize equilibria to the left of th...

Hermetic reciprocating compressor with elliptical shell radiates noise whose frequency spectrum has a peak level at about 200 Hz and about 300 Hz. The 200 Hz and 300 Hz noise is mainly radiated from the top and the side of the compressor shell, respectively. For clarifying the noise radiation mechanism, experimental and theoretical analyses were performed. A noise source simulation test was set...

In present work, a compressor configuration is taken from literature which will be studied for aspect ratio (ratio between length of blade to chord length) influence over performance. Performance in the sense is pressure ratio of compressor. The aspect ratio of the blade is an important parameter and has a strong influence on the performance of axial flow compressor. There are so many literatur...

A method to determine the economic cost of gas turbine compressor fouling was developed. The method is based on the calculation of the influence of the drop of compressor performances (isentropic efficiency, pressure ratio and air mass flow) on Heat Rate and full load power of the gas turbine. A statistical procedure to quantify the drop of compressor performances with fouling and to obtain amb...