The prosthodontist encounters increasing problems in the fabrication of a well functioning complete denture over a resorbed edentulous ridge. The objective of this study was to clinically evaluate the efficacy of the soft acrylic denture compared to conventional one when used to restore a severely resorbed ridge. Both quantitative and qualitative parameters were assessed. Quantitative parameter...

PURPOSE This report of a clinical patient series indicates the relative safety and illustrates the procedures involved in the extraction of remaining teeth followed by immediate implant placement and loading with a simple acrylic resin fixed denture. MATERIALS AND METHODS Ten consecutive patients who selected tooth extraction and implant-supported fixed denture rehabilitation of the mandible ...

The purpose of this study was to verify the influence of flask closure methods and post-pressing times on tooth displacement in maxillary dentures. Twenty similar maxillary dentures were made using a heat-polymerized acrylic resin, and randomly assigned to 4 experimental groups (n=5) according to the protocol: 1-conventional flask closure and immediate polymerization; 2- conventional flask clos...

Dental rehabilitation of a completely edentulous geriatric patient has always been a challenge to the clinician, especially in treating those with higher expectations and demands. Treatment duration and the amount of residual alveolar bone available are often important considerations when planning for dental implant-based fixed treatment for these patients. With the introduction of zygomatic im...

Although immediate implantation has not been previously recommended in infected sites, it is now becoming a procedure of choice in modern implant dentistry. We report a case of a 65-year-old male patient, who required multiple tooth extractions in the lower jaw and fabrication of a new overdenture in the lower jaw and a complete denture in the upper jaw. Immediate implantation in infected tooth...

PURPOSE The aim of this study was to compare the color stability, water sorption and cytotoxicity of thermoplastic acrylic resin for the non-metal clasp dentures to those of thermoplastic polyamide and conventional heat-polymerized denture base resins. MATERIALS AND METHODS Three types of denture base resin, which are conventional heat-polymerized acrylic resin (Paladent 20), thermoplastic po...

This case report describes a simple method for identifying the citizenship of a denture wearer by marking the telephone country code number inside the denture base. A wax pattern for the denture framework was prepared on the refractory cast. A piece of embossing tape, containing the country code (81, Japan), Japanese prefectural code, and abbreviation of the dental clinic where the denture was ...

Liquid supported denture can be a permanent solution in edentulous patients with atrophied ridge. A complete denture is designed so that the base is covered with a pre-shaped, close fitting flexible foil containing a thin film of high viscosity liquid. Liquid-supported dentures will have optimal stress distribution during masticatory function. It will act as a continuous reliner for the denture...