Utilisation of fly ash and Ground Granulated Blast Slag as an alternative material in concrete reduces the use of OPC in concrete. Evolution of geopolymer concrete cured at ambient temperature broadens its suitability and applicability to concrete based structures. This paper presents the mix proportions and outcome of an experimental study on the density and compressive strength of geopolymer ...

This study investigates the influence of curing age and mix proportions on the compressive strength of volcanic ash (VA) blended cement laterized concrete. A total of 288 cubes of 100mm dimensions were cast and cured in water for 3, 7, 28, 56, 90 and 120 days of hydration with cement replacement by VA and sand replacement by laterite both ranging from 0 to 30% respectively while a control mix o...

The performance of concrete primarily depends upon the type and ratio of its constituents, compaction, curing conditions and admixtures used during curing process. Part of this research emphasis to calculate the consequences on strength of concrete when water-cement ratio is constant and the increase in slump occurs with the increase in amount of superplasticizer by percentage. The rest of the ...

The results reported in this paper are the part of an extensive laboratory investigation undertaken to study the effects of fibre parameters on the permeability and strength characteristics of steel fibre reinforced concrete (SFRC). The effect of varying fibre content and curing age on the water permeability, compressive and split tensile strengths of SFRC was investigated using straight steel ...

This paper investigates the effect of testing variables including curing conditions (65% vs>95% RH), time of demoulding and specimen geometry (cylinder vs cube) on the compressive strength of hemp concrete. It studies hydration in the concrete’s microstructure and measures compressive strength development at intervals between 1 day and 1 month. Moulding time and curing conditions influence dryi...

Monitoring the strength of concrete structures in their early stages is critical to avoid failure and determine readiness for use. Automatic curing also important minimize water waste, prevent cracks, achieve a long-lasting structure.To facilitate automatic curing, moisture sensor utilized. Generally, process takes 28 days, which crucial attaining desired strength. This study developed that aut...

Portland cement concrete (PCC) has been successful in many applications. However, since the 1960s technological investigations concerning modifications of concrete by polymeric materials have been conducted. Attention has been focused on concretes in which the continuous phase is some kind of polymeric resin and the discrete phase is some type of mineral aggregate. Such composite materials are ...

High performance concrete (HPC) requires a low water-to-cementitious materials mass ratio (w/cm), often with the inclusion of supplemental cementitious materials such as silica fume in the mixture, thus necessitating the use of a superplasticizer. Because of the low w/cm and rapid reaction at early ages, proper curing from the earliest time possible is very essential in HPC. Internal curing has...