نتایج جستجو برای: flow pressure

تعداد نتایج: 840756  

دمیری, ذبیح اله, شریفی, جواد, یاراحمدی, رسول,

Introduction: Nowadays, many modern industries require an environment with no contamination by particles and bacteria. An enclosed clean room environment is a place where parameters such as airborne particles, temperature, humidity, air pressure and air flow pattern is controlled. The aim of this study was to evaluate functional parameters of a clean room  in a selected pharmaceutical industry....

Journal: :محیط شناسی 0
محمدرضا جلیلی قاضی زاده استادیار دانشکده عمران، آب و محیط زیست، دانشگاه شهید بهشتی ضیاالدین ایدی دانشجوی دکتری سازه های هیدرولیکی، دانشگاه رازی

extended abstract abstract pressure management is an effective method for water demand management. for evaluation of the effects of pressure changes on leakage level of water networks, the favad equation is usually used. however, in this equation, exponent of pressure parameter (n) needs to be determined. for estimation of n, either some information about the leak opening is necessary or networ...

Journal: :تحقیقات موتور 0
امید صمیمی ابیانه o. samimi abianeh سید مصطفی میرسلیم s.m. mirsalim احمد شفیعی ثابت a. shafiei sabet

gas motion within the cylinder is one of the major factors that control the combustion process in spark ignition engine. it also has significant impact on heat transfer. both the bulk gas motion and the turbulence characteristics of the flow are important and governing the overall behavior of the flow. an arrangement for obtaining a stratified charge, using port injection, is proposed for a cur...

Journal: :مکانیک سیالات و آیرودینامیک 0
نیما سام خانیانی محمدرضا انصاری

in this paper, direct numerical simulation of two-phase incompressible gas-liquid flow for simulation of bubble motion in a microtube is presented. microtube radius is 10 µm. the interface is tracked using volume of fluid (vof) method with continuous surface force (csf) model. the flow is solved using a finite volume scheme, based on piso algorithm. numerical simulation is performed on a axisym...

Journal: :journal of membrane science and research 0
fatemeh khazaali department of petrochemical engineering, amirkabir university of technology (tehran polytechnic), mahshahr campus, mahshahr, iran ali kargari department of chemical engineering, amirkabir university of technology (tehran polytechnic), tehran, iran

in this paper, the removal of phenol by using aqueous solution in a low pressure reverse osmosis membrane was investigated. the effect of feed pressure, feed concentration, feed flow rate and feed ph on phenol rejection was investigated. the results showed that feed ph is the most affective parameter on the phenol rejection. rejection of phenol increased with increasing ph from 2 to 10 under th...

The accurate prediction of wellbore temperature distribution helps to accurately estimate well pressure profile and bottom-hole pressure (BHP) which is important in the under-balanced drilling (UBD) operation. In this paper effect of temperature variation due to heat transfer of drilling fluid with the formation and also oil and gas production from the reservoir into the annulus in under-balanc...

In this paper, effects of EHD actuators on hydrodynamic behavior and heat transfer of air flow over a circular cylinder were considered. Pressure and temperature distributions around the cylinder were measured in presence of wire-plate EHD actuators. The Reynolds number based on cylinder diameter (d) were 3500, 7000. Experiments were performed for various configurations. Based on obtained resul...

This research has been carried out to determine the marine propeller hydro-acoustic characteristics by Reynolds-Averaged Navier-Stokes (RANS) solver in both uniform and non-uniform wake flow at different operating conditions Wake flow can cause changes in pressure fluctuation and gas effect on propeller noise spectrum. Noise is generated by the induced trailing vortex wake and induced pressure ...

ASGARY K., , ATTAR E., , BABAEI R., , DAVAMI P., , HOMAYONIFAR P., ,

During mold filling, molten metal can only advance as quickly as the air inside thecavity is expelled. In this work an analytical model describing air flow is developed based on aincompressible flow theory. Air pressure has serious effects upon the filling behaviour such assurface profile and filling time. In this work a new mathematical model is proposed for calculationthe air pressure during ...

The one dimension computational model of a sequential injection engine, which runs on compressed natural gas (CNG) with spark ignition, is developed for this study, to simulate the performance of gas flow pressure profile, under various speed conditions. The computational model is used to simulate and study of the steady state and transient processes of the intake manifold. The sequential injec...

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید