An enhanced unfolding Inverse Finite Element Method (IFEM) has been used together with an extended strain-based forming limit diagram (EFLD) to develop a fast and reliable approach to predict the feasibility of the deep drawing process of a part and determining where the failure or defects can occur. In the developed unfolding IFEM, the meshed part is properly fold out on the flat sheet and tre...

one of the great challenges in the processing of materials using equal channel angular pressing (ecap) is the high forming forces required to produce large shear deformation in the material. researchers show that the friction forces between the die and the sample constitute a great part of the total forming forces. recently, ultrasonic vibrations are successfully implemented into the ecap proce...

laser forming is a modern process which is mainly used for forming metals. different lasers are used in this regard that includes nd: yag and co2. in this study, forming bi-layer sheets of aluminum/ceramic by laser was investigated. furthermore, effect of uniform and gaussian heat flux distribution in different power, velocity, and beam diameters on bending angle was studied. fem simulation ind...

hydro-forming is a fabrication process that uses a fluid medium to form a piece by using high internal pressure. in tube hydro-forming, a tubular blank is placed between two dies, sealed and pressurized water injected, deforming the tube walls in the cavity form of the dies. exist several typical hydro-forming processes such as t- shapes, cross-shapes and y- shapes. successful hydro-forming dep...

the incremental sheet metal forming (ismf) process is a new and flexible method that is well suited for small batch production or prototyping. this paper studies the use of the finite element method in the incremental forming process of aa1050 sheets to investigate the influence of tool diameter, vertical step size, and friction coefficient on forming force, spring-back, and thickness distribut...

In this paper, the design and implementation of plasma antenna array with beam forming is discussed. The structure consists of a circular array of plasma tube enclosed in a unipolar UHF band monopole antenna. Beam forming is possible by stimulated plasma tubes. The combination of the above antenna with plasma excitation controller makes a beam forming smart antenna. An experimental model in UHF...

Bioethics has become a prominent part of the American landscape. In only a few short decades this interdisciplinary field permeated academia and the public sphere. Despite the recent scholarly effort to chronicle its history, there is still quite a bit of controversy surrounding bioethics’ origin and rapid evolution. Bioethics’ emergence has already been thoroughly examined through the lens of ...

In sheet metal forming processes with complex strain paths, a part is subjected to large plastic deformation. This severe plastic deformation leads to high plastic strain localization zones and subsequent accumulation of those strains. Then internal and superficial micro-defects and in other words ductile damage is created. This damage causes quality problems such as fracture. Therefore, design...

forming limit curves are used as a parameter in finite element analysis to control the material's level of formability. in this research, forming limit diagram (fld) of ss304l sheet was obtained by abaqusfinite element software. in practice, the experimental determination of a forming limit curve is a very time-consuming procedure which requires special and expensive equipment. forming limit di...

shape error due to elastic recovery of formed part in unloading known as springback, is one of the most important problems of tool design in sheet metal forming processes. many researches have been performed for proposing an efficient method to decrease or compensate springback error in sheet forming processes. these methods are usually based on iterative finite element algorithms. in this pape...