Externally bonded carbon-epoxy fiber-reinforced polymers (CFRPs) have been widely used to restore or increase the capacities of reinforced concrete beams (Meier et al., 1992; Neale and Labossière, 1997; Varastehpour and Hamelin, 1997). A typical reinforced concrete bridge deck may experience up to 7x10 stress cycles during the course of a 120year life span (Barnes and Mays, 1999), while an over...

the current study is focused on strengthening of reinforced concrete (rc) beams using cfrp straps installed in pre-cut grooves. the method which is referred as near surface mounted (nsm) benefits considerable advantages in comparison with the conventional externally bonded reinforcement (ebr) method and provides better normal and shear stress transfer between the frp and concrete substrate. the...

The project is a continuation from fiscal year 2004-2005. Previous work aimed at developing new analytical tools for analysis of RC beams strengthened with FRP laminates. The models were used to analyze several test specimens of RC beams and to investigate the corresponding failure mode, and whether it is due to CFRP fracture, debonding, or concrete crushing. Current work focused on using the e...

Abstract The approach for seismic strengthening of RC frames using moment redistribution and externally bonded FRP is especially applicable enhancing the performance a building that designed prior to introduction new codes. design detailing requirements these categories were conducted following capacity principle. Based on more recent codes, buildings are under-designed, has become mandatory. A...

Fiber Reinforced Polymer (FRP) systems have gained much popularity as a method for reinforcing existing concrete structures. However a variety of sudden failure methods, such as debonding, delamination, and creep rupture have led to the development of code limitations on the strength that an FRP system can be considered to provide. The uncertainty brought on by the failure methods mentioned abo...

This paper identifies assessment techniques for critical parameters relative to installation and performance of fiber reinforced polymer (FRP) materials as a way to strengthen structurally deficient concrete bridges. Various Nondestructive Testing (NDT) techniques, representing viable solutions for identification and monitoring of such critical parameters on structural members strengthened with...

This paper presents an experimental program dealing with the shear strengthening with FRP systems of URM walls built with concrete and clay units. Ten concrete and five clay masonry panels, strengthened with FRP composites in the form of laminates and rods, and stainless steel, were loaded along the wall diagonal to observe their shear performance. The dimension of the concrete masonry panels w...

As the life age of the existing structures are required to meet the changing demands on civil infrastructures. So strengthening and retrofitting are required. Recently many techniques to strengthen the reinforced concrete beams in flexural by using fiber reinforced polymer (FRP) had appeared. The most famous technique among them is strengthening the (RC) beams with externally bonded FRP sheet t...

Passively damped bracing systems in steel frames, in which the conventional materials of the joint are replaced by high damping viscoelastic materials, have the potential of being effective practical means for passive vibration control of dynamically loaded civil engineering structures. However, this potential can be realized only if the associated structural penalties are reduced within accept...

The mechanical behavior of the adhesive interface between the fiber-reinforced polymer (FRP) strip and the concrete substrate often controls the response of FRP-strengthened reinforced concrete (RC) members. Plenty of studies devoted to understanding the mechanical behavior of FRP strips glued to concrete are currently available in the scientific literature. However, they are mainly focused on ...