Two Cu-Co and Co3O4 oxides were synthesized by the conventional sol-gel auto-combustion and their physical-chemical properties were characterized by XRD, FTIR, SEM, TPR and XPS. The XRD results indicated that copper-cobalt oxide appeared in a mixture form of Cu0.15Co2.85O4 spinel and CuO phases, whereas the cobalt oxide exhibited in the pure form of Co3O4 spinel. The FTIR approved the formation...

ZnO and ZrO2 photo catalysts were synthesized by sol-gel auto combustion method. The products were characterized by X-ray Diffraction (XRD) and Scanning Electron Microscopy (SEM). Structural and morphological properties of nano particles were investigated and the average crystalline size of ZnO and ZrO2 was obtained 44 and 51 nm, respectively. Also, photo catalytic degrada...

homogeneous charge compression ignition (hcci) combustion is a pioneer method of combustion in which pre-mixed fuel and oxidizer (typically air) are compressed to the point of auto-ignition. hcci engines can operate with most alternative fuels, especially, dimethyl ether (dme) which has been tested as a possible diesel fuel due to its simultaneously low nox and pm emissions. in this paper a sin...

Zinc ferrite (ZnFe2O4) nanoparticles were synthesized via the auto-combustion assisted sol-gel method of Zn2+ and Fe3+ ions (molar ratio 1:2) in ammonia solution. The prepared nanomagnetic catalyst was characterized by IR, XRD, SEM and ICP. The diameter of the ZnFe2O4 MNPs (63.7 nm) was determined by Debye-Scherre equation via their XRD pattern. Nanomagnetic ZnFe2O4 efficiently catalyzes oxidat...

ZnO and ZrO2 photo catalysts were synthesized by sol-gel auto combustion method. The products were characterized by X-ray Diffraction (XRD) and Scanning Electron Microscopy (SEM). Structural and morphological properties of nano particles were investigated and the average crystalline size of ZnO and ZrO2 was obtained 44 and 51 nm, respectively. Also, photo catalytic degrada...

Zinc ferrite (ZnFe2O4) nanoparticles were synthesized via the auto-combustion assisted sol-gel method of Zn2+ and Fe3+ ions (molar ratio 1:2) in ammonia solution. The prepared nanomagnetic catalyst was characterized by IR, XRD, SEM and ICP. The diameter of the ZnFe2O4 MNPs (63.7 nm) was determined by Debye-Scherre equation via their XRD pattern. Nanomagnetic ZnFe2O4 efficiently catalyzes oxidat...

A new combustion model is developed and applied to simulate combustion in dual-fuel engines in which the premixed natural gas is ignited by the combustion flame initiated by a diesel spray. The model consists of a diesel auto-ignition model and a flame propagation model. A G-equation model previously developed to simulate SI engine combustion was incorporated with an auto-ignition model to simu...

In this paper, LaBO3 perovskite type catalyst formulations were prepared by sol-gel auto combustion method using citric acid as the fuel. Activity of catalysts was tested in catalytic oxidation of toluene as a model of volatile organic compounds. LaCoO3 perovskite formulation showed the highest activity among LaBO3 (Fe, Mn and Co) perovskite catalysts. So, LaCoO3 perovskite based catalyst was s...