A heat exchanger using nanofluid needs to operate at optimum mass concentration level to get the maximum heat transfer performance. A numerical analysis is performed on the heat transfer and pressure drop of water-based γ-Al2O3 nanofluid gasketed-plate heat exchanger to specify its optimum conditions. Cold water will be heated by γ-Al2O3/water nanofluid. The results showed that optimal volume c...

The development and production of high performance equipment necessitate the use of passive cooling technology. In this paper, heat transfer study of convective-radiative straight fin with temperature-dependent thermal conductivity under the influence of magnetic field is carried out using Legendre wavelet collocation method. The numerical solution is used to investigate the effects of magnetic...

in this paper the numerical analysis of flow and time dependent heat transfer of micro-tube conveying nanofluid in laminar flow is investigated. in this study, convection heat transfer of nanofluid and base fluid and transient analysis for time-varying heat flux for time step of 0.0001 second are elucidated. it is observed that the pumping power of nanofluid flowing and the maximum temperature ...

In internal combustion engines, exhaust valve and its seat gain considerable temperature as the hot gases exit through them. So, the rate of heat transfer should be under control. In this study, the contact heat transfer coefficient has been estimated. An experimental study on an Air-Cooled internal combustion engine cylinder head has been considered. Using the measured temperatures of sensors ...

using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. in this work two-dimensional incompressible laminar flow of a nanofluid e...

sometimes the need for non-circular ducts arises in many heat transfer applications because of lower pressure drop of non-circular cross section such as square duct compared to circular tube, particularly in compact heat. but square cross section has poor heat transfer performance and it is expected that using a nanofluid as a new heat transfer media may improve the heat transfer performance of...

abstract: in this study, al 2 o 3 /eg and tio 2 /eg nanofluids as coolants have been used in the double-tube heat exchanger. the hot solvent inlet heat exchanger must be cooled down with a specified amount. we can use nanofluids as coolants in the heat exchanger for optimization of the heat transfer area. therefore, the efficacy of nanofluids as coolants is verified. furthermore, flow rate of c...

fridges are used in various industries, and heat exchanger is one of the main components of these systems; therefore, efficiency analysis of these systems is very important. in many fridges, frost over the heat exchanger tubes or pipes affects the system operation and reduces heat transfer between the refrigerant and ambient, so defrosting systems are usually used to enhance heat transfer. desi...

small scale thermal devices, such as micro heater, have led researchers to consider more accurate models of heat in thermal systems. moreover, biological applications of heat transfer such as simulation of temperature field in laser surgery is another pathway which urges us to re-examine thermal systems with modern ones. non-fourier heat transfer overcomes some shortcomings of fourier heat tran...

In this paper, the non-Fourier heat conduction in a semi-infinite body was examined. The heat wave non-Fourier heat conduction model was used for thermal analysis. Thermal conductivity was assumed temperature-dependent which resulted in a non-linear equation. The heat source was also considered temperature-dependent which resulted in a non-homogeneous equation. The Mac-Cormack predictor-correct...