in this investigation, continuous cooling transformations and microstructures have been studied in detail in a low carbon ti-nb bearing microalloyed steel by means of dilatometry, metallography and hardness measurements. the results indicate that when the cooling rate is greater than 1˚c/s, the dilatation curve is associated with a major dilatation at relatively low transformation temperatures,...

The effects of intercritical annealing and subcritical tempering on the mechanical properties and corrosion resistance of mild steel were studied. It was revealed that intercritical annealing followed by quenching resulted in the development of a ferritic-martensitic dual phase (DP) microstructure with high tensile strength, disappearance of the yield-point phenomenon, superior work-hardening b...

The effect of microstructural refinement and intercritical annealing on the mechanical properties and work-hardening response of a low carbon St12 steel was studied. It was revealed that intercritical annealing of the ferritic-pearlitic sheet results in the formation of a coarse-grained DP microstructure with discrete martensite islands normally formed in place of pearlitic colonies, which resu...

Several types of reduced activation ferritic/martensitic (RAFM) steel have been developed over the past 30 years in China, Europe, India, Japan, Russia and the USA for application in ITER test blanket modules (TBMs) and future fusion DEMO and power reactors. The progress has been particularly important during the past few years with evaluation of mechanical properties of these steels before and...

Precipitation-hardened (PH) stainless steels have been widely used as structural materials and related applications in marine environments, power plants (light-water and pressurized water reactors), and chemical industries because of their good mechanical properties and corrosion resistance at typical service temperatures below 300oC. 17-4 PH (A1S1630) stainless steel (15–17.5 Cr, 3–5 Ni, 3–5 C...

The microstructure of 8 mm diameter wire produced by the severe deformation of 316L austenitic stainless steel has been examined using TEM and X-ray diffraction. The deformation imparted amounts to a true strain of 6.3. Data from previous studies on strain induced transformation of this steel have been combined with new results to show that true strains .2 are required in order to observe mecha...

behaviors of stress corrosion cracking (scc)in martensitic stainless steel(aisi 420) and low carbon austenitic stainless steel (aisi 316l) have been compared under different conditions of temperature, environment (mgcl2), and strain rate. the results show that decreasing strain rate has detrimental effect on mechanical properties of both steels, including their strength and ductility. fractogra...

Calculations verify that carbon diffusion may occur during the lath martensite fomtion. Accordingly,the diffusion of int2rstitial ator ions must be taka into account nhfn martmitic transformtion is defined as a diffusionless transformation. In derivation of the kinetics equation of the ath& martensitic transfomtion,rzgardng the c a r h diffusion, i .e.the enrichment of the austenite during the ...

color metallography is a useful method for characterizing microstructures of steels with multiple phases. in this paper, application of three different color etching techniques for a bainitic-martensitic steel is reported. comparisons between the results showed that 10% na2s2o5 aqueous solution was the best etchant for distinguishing martensite, bainite and ferrite phases. the obtained microgra...

A method based on the kinetics of crystal growth has been developed and applied to the computation of three-dimensional microstrucuture in austenite-matensite steels. The detailed crystallography of the transformation is used to model a realistic martensitic microstrucuture during the transformation without an external system of stresses. The interaction energy based on the plastic work model i...