A 1.2V 5GHz low-cost voltage-controlled oscillator (VCO) with active common mode feedback has been implemented in a CMOS/RF 90nm technology for a robust I/Q generation using a frequency divider-by-2 (DIV2). As the input common mode of the DIV2 affects critically its performance, a calibration method to correct the output common mode of the VCO has been proposed and validated through post-layout...

In this paper, PLL are most frequently used for Local Oscillator (LO) signal generation in wireless radio transceivers to down convert the carrier frequency to lower or intermediate frequency . The input reference frequency is 6.4 MHz. The architecture used for the design of Frequency synthesizer was Integer-N architecture. This was designed using 0.25 μm technology. The VCO designed was a CMOS...

An arbitrary multi-way radial power divider/combiner with high-power capacity based on the coaxial waveguide TE 01 -mode is presented in this paper. The study of shows divider can operate base mode a large diameter, which allow waveguides to be radially distributed along circumference waveguide. equivalent circuit model used analyze its design procedure including matching section, improve trans...

A study and comparison between current mode CMOS analog multiplier, CMOS current mode multiplier/divider and high frequency four quadrant current multiplier has been carried out in this paper. Current multiplier has been simulated in SPICE with 0.35μm, 0.5μm. Simulation have been done with supply voltage of 3.3V, 1.5V and 1.55V respectively. The simulated results show that characteristic of mul...

In this article, a static frequency divider based on folded MOS current mode logic (FMCML) is presented. The design alternating FMCML flip-flops with complementary pMOS or nMOS input differential pairs since common-mode problems arise by using only one type of flip-flops. carried out after detailed theoretical modeling and analysis versus the flip-flop bias current, thus allowing defining optim...

In this paper, a new approach for design of a fully differential second order current mode continuous-time sigma-delta modulator is presented. For circuit implementation, square root domain (SRD) translinear loop based on floating-gate MOS transistors that operate in saturation region is employed. The modulator features, low supply voltage, low power consumption (8mW) and high dynamic range (55...

In this paper, the closed-form design method of an Nway dual-band Wilkinson hybrid power divider is proposed. This symmetric structure including N groups of two sections of transmission lines and two isolated resistors is described which can split a signal into N equiphase equiamplitude parts at two arbitrary frequencies (dual-band) simultaneously, where N can be odd or even. Based on the rigor...

Combination of A/D-D/A converters allows implementing both long-term analog memory and multiplier/divider operations. An efficient design based on continuous-time, current-mode, dividing-algorithmic converters is presented in this paper. It offers high-speed and low-voltage operation with low or middle resolution. Experimental results of two CMOS-2.4μm prototypes (with 5and 7-bit data converter...