The kinetics of changes in the concentration toxic components under γ-irradiation industrial wastewater from an oil refinery presence nano-γ-Al2O3 has been studied. phenols, surfactants, COD and total content products at various adsorbed dose were monitored. UV - spectrometric studies irradiated samples range 200-400 nm shows, that increasing absorbed leads to a decrease absorption (Abs) region...

two-component reaction of 2-aminobenzophenones with acetylenic esters in the presence of γ-al2o3 and cu/zno as suitable heterogeneous catalysts has been studied. nano γ-al2o3 and cu/zno showed high activities when used as surface catalysts for the synthesis of quinoline derivatives. after completion of the reaction, the catalyst was recovered and reused several times under the same reaction con...

In this paper, a remote O2 ion source is used for the formation of nano-oxide layers. The oxidation efficiency was measured in CoFe-oxide films, and a decrease of the oxide layer with the pan angle and the oxidation pressure is observed. For the same oxidation pressure, the oxidation efficiency depends on the O2 content in the Ar–O2 plasma. These results were applied in optimizing the fabricati...

Abstract In the present work, nano-Aluminum oxide (Al2O3), nano-Silicon Carbide (SiC), or a hybrid of them were infused into epoxy resin with an ultrasonic system various weight percentage ratios nanoparticles. Small punch testing (SPT) and indirect tension adopted to measure tensile properties nanocomposites. Pin-on-ring wear was also performed examine performance Al2O3 SiC The Finite Element ...

friction stir processing was applied for fabricating an aluminum alloy based hybrid nano composite reinforced with nano sized al2o3 and micro sized graphite particles. a mixture of al2o3 and graphite particles was packed into a groove with 1 mm width and 4.5 mm depth, which had been cut in 5083 aluminum plate of 10 mm thick. packed groove was subjected to friction stir processing in order to im...

The goal of this paper is to experimentally study the behavior of nanofluid to improve the performance of a circular heat pipe. Pure water and Al2O3-water based nanofluid are used as working fluids. An experimental setup is designed and constructed to study the heat pipe performance under different operating conditions. The effect of filling ratio, volume fraction of nano-particle in the base f...

Abstract: Composite specimens were prepared by dispersion of various amounts of nano-sized Al2O3 fillers in a monomer system containing 60% Bis-GMA and 40% TEGDMA. For comparative purposes, composite samples containing micrometer size Al2O3 fillers were also prepared following the same procedure. The mechanical properties of the light- cured samples were assessed by three-point flexural strengt...

Improved resistive switching memory characteristics by controlling the formation polarity in an IrOx/Al2O3/IrOx-ND/Al2O3/WOx/W structure have been investigated. High density of 1 × 1013/cm2 and small size of 1.3 nm in diameter of the IrOx nano-dots (NDs) have been observed by high-resolution transmission electron microscopy. The IrOx-NDs, Al2O3, and WOx layers are confirmed by X-ray photo-elect...

Investigation was to study the influence of pulse-impact on microstructure of Liquid-Phase-Pulse-Impact Diffusion Welding (LPPIDW) welded joints of aluminum matrix composite SiCp/A356, SiCp/6061Al, Al2O3p/6061Al. Results showed that under the effect of pulse-impact: 1) the interface state between reinforcement particle (SiC, Al2O3) and matrix was prominently; 2) the initial pernicious contact-s...