A suction line of a refrigeration cycle with vertical upward flow is one area where the refrigeration oil tends to accumulate. This paper discusses the flow characteristics of the oil film in a pipe with the vertical upward flow. Air and oil two-phase flow is used as the first step of the study and the flow pattern of the oil film in the vertical upward flow is observed. The oil film thickness ...

Two different tools, the non-empirical resolvent analysis and the data-based dynamic mode decomposition, are employed to assess the changes induced by transpiration in the dynamics of a turbulent pipe flow. The focus is on very large-scale motions. Both analyses permit the observation of streamwise waviness in the large flow structures and how the transpiration can inhibit fluctuation in locali...

Asymptotic expansions for small Strouhal number, valid for arbitrary subsonic Mach number, are derived for the solution of a simple problem of the interaction between an acoustic wave, a jet flow and a pipe, based on Munt's [ l ] exact formal solution. These expansions relate to the pressure and velocity fluctuations in the jet flow and in the far field, and to the reflection coefficient, end-i...

in this work, three-dimensional turbulent forced convection flow through a b-type section pipe, which porous material inserted at the bottom wall, is investigated numerically. the b-type section pipe are used in cooling systems, such as cars’ radiators. the main purpose of this research is to enhance heat transfer and to reduce the scales of such systems. the governing equations are formulated ...

The steady behavior of a rarefied gas in a circular pipe with a saw-like temperature distribution increasing and decreasing periodically in the direction of the pipe axis is investigated numerically by means of the direct simulation Monte Carlo method. It is shown that a steady one-way flow is induced in the pipe without the help of a pressure gradient for a wide range of the Knudsen number whe...

In this paper, in order to understand the flow-pipe interaction more clearly, the variations on flow pattern around semi-buried pipelines due to steady current have physically and numerically been investigated. In physical modeling section, the experiments have been carried out in a flume with 10 meter length, 0.3 meter width and 0.5 meter depth using a P.V.C pipe with 6.35 cm in diameter (for ...

Laminar and turbulent pipe flow of a ferrofluid with an imposed linearly polarized, oscillating, magnetic field is examined here. Experimental results show a fractional pressure drop dependence on flow rate, magnetic field strength, and oscillation frequency. Calculations are presented, which show that ferrofluid theory can explain the flow phenomena in laminar and turbulent pipe flow. The mode...

Heat transfer improvement in circular pipe by using nanofluid and twisted tape is presented in this review paper. Experimental and numerical studies are incorporated involving both the range of turbulent and laminar flow. Effect of type and volume fraction of nanofluid on performance of heat transfer was referred along with the length and twist ratio of the tape through the pipe on heat transfe...

In this investigation, a flow rate estimation guided wave based scheme in pipes is proposed. The effect of the fluid over the propagation of longitudinal waves has been experimentally studied by using several laminar flows of water transported by a steel pipe. Results have shown a decrease of the guided wave pattern repeatability and the signal energy as the flow rate increase as a result of th...

Temperature fluctuation in fluid causes high cycle thermal fatigue in shroud structure according to its amplitude and frequency. There are still some incidents of thermal fatigue and leakage in light water reactors (Japanese PWR Tomari-2 in 2003, French PWR CIVAUX in 1998), and also in sodium cooled reactors (French FBR PHENIX in 1992). Mixing tee is a typical component where temperature fluctu...