Application of thermoplastic materials has increased dramatically in recent decades due to its recyclability, low density, resistance to chemical changes. The friction stir welding process is one of the new methods of solid state welding, which has recently undergone a significant improvement. In this research, using a new tool Made of plain carbon steel st37 in friction stir welding and low co...

Magnetic abrasive finishing (MAF) is a micromachining process that uses magnetic field and magnetic abrasive particles to conduct the mechanism of material removal in micro-nanometer scales. In this paper, by an experimental method and statistical analysis, the effects of parameters like working gap, work-piece rotational speed and material removal mechanism (injection of abrasive slurry of Al<...

agglomeration followed by pelleting is an efficient method to decrease transport costs and increase economic efficiency of composting municipal waste. the moisture content of compost is the most important parameter of the pellet making process for any type of manufacturing device. the experiments in this study were done at moisture contents of 35%, 45% and 50% at extruder shaft rotational speed...

In magnetic abrasive finishing (MAF), abrasive grains as a tool move on surface and can remove chip from surface of work piece. In this study AL 6061 tube was considered as the work piece and the effect of finishing parameters such as gap distance between tube and poles, rotational speed of tube, abrasive ration and finishing time on surface roughness was investigated. The mixture of ferromagne...

In magnetic abrasive finishing (MAF), abrasive grains as a tool move on surface and can remove chip from surface of work piece. In this study AL 6061 tube was considered as the work piece and the effect of finishing parameters such as gap distance between tube and poles, rotational speed of tube, abrasive ration and finishing time on surface roughness was investigated. The mixture of ferromagne...

in this paper, hardness and tensile properties of welded zone of aluminum 1100 alloys by friction stir welding process was investigated and the effects of rotational and traverse speeds of tool on these parameters was studied. also the fracture cross-section of welded samples was investigated. according the results of this paper, the hardness of weld material is higher than base material and is...

this paper presents the effects of geometric tolerances on the rotating shafts natural frequencies. due to modeling the tolerances, a code is written in matlab 2013 software that produces deviated points. deviated points are controlled by different geometric tolerances, including cylindricity, total run-out and coaxiality tolerances. final surfaces and models passing through the points are crea...

In this paper experimentally, the friction-stir welding of the polypropylene sheets with 40% glass fiber has been investigated. Comparison to other welding methods, the strength of the joint is the most important feature in this process. Many parameters such as tool geometry, rotational speed, linear velocity, and tilt angle are very important as input parameters in this type of welding. Theref...

hot rolling of a large ring of titanium alloy (lrt) is a highly nonlinear incremental forming process with coupled mechanical and thermal behaviors (mtbs) which significantly affect microstructure and properties of the ring. the feed rate of idle roll and the rotational speed of driver roll have major effects on ovality of the ring. in this paper, the effects of these parameters on the ovality ...