In the present study, an investigation into wear properties has been carried out to identify the influence of ZrO2 as the reinforcement material on the LM25 MMC composite. Aluminum LM25 is selected as the base material, and it is reinforced with varying proportions of 0, 3, 6, 9, 12 and 15% of zirconia (ZrO2) manufactured by stir casting. Six tensile test and wear test samples were prepared acc...

In this paper we investigate the tribological properties of AlSn-based alloy with different amount of graphite at different normal loads and sliding speed. A modified impeller mixing coupled with chill casting technique was used for the preparation of immiscible alloys. In this paper Al-Sn binary alloys was chosen for this study. This binary system shows the miscibility gap at different concent...

Wear coefficient is an important wear parameter. However, its value is often determined from wear tests which are conducted without taking into account both their transient wear and steadystate wear. This has resulted in wear coefficient values varying greatly from one case to another when they are determined by different investigators, making meaningful comparison difficult. Research work done...

Friction and wear are detrimental to engineered systems. Ultrasonic lubrication is achieved when the interface between two sliding surfaces is vibrated at a frequency above the acoustic range (20 kHz). As a solid-state technology, ultrasonic lubrication can be used where conventional lubricants are unfeasible or undesirable. Further, ultrasonic lubrication allows for electrical modulation of th...

When polymeric solids slide against other solids such as steel there appears to be no way to predict either the friction of the system or the wear life of the polymer from handbook data. Friction and wear vary over wide ranges when sliding speed, applied load and system temperature are varied. Neither have thermal analyses of the sliding system produced satisfying results, partly because of the...

The friction and wear performance of ultra high molecular weight polyethylene(UHMWPE) and pure poly-ether-etherketone(PEEK) polymers were comparatively evaluated under dry sliding and cacao drops lubrication. The sliding experiments were carried out on a pin-on-disc tribometer. The contact configuration used was a polymer pin on a rotating stainless steel disc. Wear tests were carried out at ro...

The effects of 0, 0.3, 0.6 and 0.9 wt % modifier La on the dry sliding wear behaviours of AlSi5Cu1Mg alloy were investigated under different friction conditions (normal loads, sliding velocities) by using pin-on-disc configuration. The microhardness of the alloys was tested, and it was found that the microhardness of the alloys was improved by the La addition. The AlSi5Cu1Mg + 0.6 wt % La alloy...

This study reveals the effect of TiB₂ particles on the mechanical and tribological properties of Fe₃Al-TiB₂ composite coatings against an alumina counterpart. The feedstock was produced by milling Fe₃Al and TiB₂ powders in a high energy ball mill. The high-velocity oxy-fuel (HVOF) technique was used to deposit the feedstock powder on a steel substrate. The effect of TiB₂ addition on mechanical ...

friction stir processing was applied for fabricating an aluminum alloy based hybrid nano composite reinforced with nano sized al2o3 and micro sized graphite particles. a mixture of al2o3 and graphite particles was packed into a groove with 1 mm width and 4.5 mm depth, which had been cut in 5083 aluminum plate of 10 mm thick. packed groove was subjected to friction stir processing in order to im...

This work explores the effect of surface modification of stainless steel with a carbon nitride (CNx) film, under sliding wear of the UHMWPE/steel. Wettatibility of CNx coatings is assessed by means of the sessile drop method using two different liquid media. Microhardness and stiffness of CNx coatings are estimated by depth-sensing indentation. The sliding performance of UHMWPE against stainles...