Theoretical analysis and finite element (FE) simulation have been carried out for a constant specific load rate (CSLR) indentation creep test. Analytical results indicate that both the representative stress and the indentation strain rate become constant after a transient period. Moreover, the FE simulation reveals that both the contours of equivalent stress and equivalent plastic strain rate u...

Creep behavior of thick-walled functionally graded cylinder consisting of AlSiC and subjected to internal pressure and high temperature has been analyzed. The functional relationship between strain rate with stress can be described by the well known threshold stress based creep law with a stress exponent of five. The effect of imposing non-linear particle gradient on the distribution of creep s...

This paper describes a new approach which can be used to interpret the experimental creep deformation data obtained from miniaturized thin plate bending specimen test to the corresponding uniaxial data based on an inversed application of the reference stress method. The geometry of the thin plate is fully defined by the span of the support, l, the width, b, and the thickness, d. Firstly, analyt...

Abstract-The validity of the parameter (AT), (which was previously introduced by one of the authors), its meaning, and its calculation, in the analysis of cracked bodies under non-steady creep conditions, are studied. Comparisons are made with the widely used parameter C*, which is valid for steady-state creep. An efficient finite element method for general, small-strain, elasticlviscoplastic a...

Accurate predictions of the amount and the rate of long- term deformation of reinforced soils under an applied load are important key issue in geotechnical engineering, in which the deformation of soil develops with time at a state of constant effective stress. Since geosynthetic is generally considered creep sensitive therefore, evaluation of creep behavior of geosynthetic reinforced soil (GRS...

Creep deformation behaviour in single phase $\gamma$-TiAl alloy has been an extensively studied topic since the late 1970s. A lot of literatures have reported creep alloys, manufactured using different processing techniques. The present discussion revisits original work on understanding tensile wrought single-phase by Hayes et al and is aimed to develop steady state creep, through strain vs rat...