A low head recirculating aquaculture system has been designed, constructed, and is being tested at the Vriginia Tech Aquaculture Lab. Each recirculating system contains two grow-out tanks; a filtration vessel containing a microscreen drum filter; and four rotating biological contactor (RBC) biofilters; sixteen airlift pumps (eight per tank); a regenerative blower with air lines, vacuum lines, a...

Fe-2.25Cr-1Mo a widely used material for headers and steam tubes of boilers. Welding of steam tube to header is required for production of boiler. Heat affected zone of the weld can have poor mechanical properties and poor corrosion behavior leading to weld failure. The cost of material used for steam tube and header of boiler should be controlled. This study propose a new materials design for ...

In order to solve the water sealing problem of soil between pipes of long distance curved pipe-jacked technology, Freeze-Sealing Pipe Roof (FSPR) as an innovative pre-supporting method in tunnel engineering is being applied to the Gongbei Tunnel in the Hong Kong-Zhuhai-Macau Bridge. The definition of FSPR is that large diameter steel pipes are laid out in a circle around the cross section of tu...

A Modified Robbins Device (MRD) was installed in a full-scale water distribution system to investigate biofouling and metal depositions on concrete, high-density polyethylene (HDPE) and stainless steel surfaces. Bulk water monitoring and a KIWA monitor (with glass media) were used to offline monitor biofilm development on pipe wall surfaces. Results indicated that adenosine triphosphate (ATP) a...

In this investigation, a flow rate estimation guided wave based scheme in pipes is proposed. The effect of the fluid over the propagation of longitudinal waves has been experimentally studied by using several laminar flows of water transported by a steel pipe. Results have shown a decrease of the guided wave pattern repeatability and the signal energy as the flow rate increase as a result of th...

A new monitoring approach for detecting, locating, and quantifying structurally weak reaches of steel-lined pressure tunnels and shafts is presented. These reaches arise from local deterioration of the backfill concrete and the rock mass surrounding the liner. The change of wave speed generated by the weakening of the radial-liner supports creates reflection boundaries for the incident pressure...

an experiment featuring waterhammer in viscoelastic pipes is presented in which the effects of pipe-wall viscoelasticity on waterhammer pressures are investigated. a large-scale pipeline apparatus made of polyvinyl chloride (pvc) at deltares, delft, the netherlands, has been used to carry out waterhammer experiments. tests have been conducted in a reservoir-pipeline-valve system consisting of a...

Welding quality control is an important parameter for safe operation of oil and gas pipes, especially for high-strength steel pipes. Size control of welding defect is a bottleneck problem for current pipe construction. As a key part of construction procedure for butt-welding of pipes, pore defects in girth weld is difficult to ignore. A three-dimensional non-linear finite element numerical mode...

This study presents a new mechanical tube cladding process named punch plastic deformation pipe cladding (PPDPC) based on local deformation by pressing a punch into the inner layer of the bimetal tube. To investigate the capability of the process, stainless steel tube (as the inner layer) is bonded to a carbon steel pipe (as the outer layer) to fabricate a bimetal pipe. Shear punch tests were u...