Carbon fiber reinforced polymer (CFRP) sheets are externally bonded to reinforced concrete (RC) members to provide additional strength such as flexural, shear, etc. It has been widely accepted that carbon fiber reinforced polymers (CFRPs) can be used effectively to strengthen reinforced concrete (RC) members. This paper is intended to study and use externally bonded CFRP strips to repair and st...

In the present study, the effect of post-rolling annealing heat treatment on the formation of intermetallic compounds between Al-Cu strips, in the presence of nickel coating on the Cu strips, was investigated. In addition, the effect of post-rolling annealing and intermetallic compounds on the bond strength of Al-Cu strips was evaluated. In order to prepare samples, Cu strips were coated with n...

Results are reported from beam test measurements of one of the first commercial prototype gallium arsenide microstrip detectors. The detector consisted of 128 strips on a 50μm pitch, with a wafer thickness of 200μm. Operating at a bias of 180V, the detector produced a signal to noise ratio of 19 to 1, with a particle detection efficiency of better than 99%. The spatial resolution of the detecto...

We study equilibrium configurations of thin and elongated non-Euclidean elastic strips with hyperbolic two-dimensional reference metrics ā which are invariant along the strip. In the vanishing thickness limit energy minima are obtained by minimizing the integral of the mean curvature squared among all isometric embeddings of ā. For narrow strips these minima are very close to minimal surfaces r...

We investigate the mechanism by which topological defects form in first order phase transitions with a charged order parameter. We show how thick superconductor vortices and heavy cosmic strings form by trapping of magnetic flux. In an external magnetic field, intermediate objects such as strips and membranes of magnetic flux and chains of single winding defects are produced. At non-zero temper...

Once convinced in his own mind that Insulite was the best available substance, Jarvis ordered the construction of several experimental tees for the Galloping Hills course. Strips were cut from the board, 2V2 inches in width and 5 feet in length. The material is approximately V2 inch in thickness. Boxes to hold the strips were then built, 5 by 10 ft., 2 in. in height. At first they were construc...

Statement of problem. The effect of gold electroforming on gold alloy was not studied. Purpose. This in vitro study investigate the effect of gold electroforming on gold-silver-palladium alloy. Material and methods. Three pieces of gold strips had undergone the electroforming procedures on one side and then half of the side again electroformed. The set mode for this study was program 1 (200 μm)...

The development of co-electrospun (co-ES) hollow microfibrous assemblies of an appreciable thickness is critical for many practical applications, including filtration membranes and tissue-mimicking scaffolds. In this study, thick uniaxially aligned hollow microfibrous assemblies forming fiber bundles and strips were prepared by co-ES of polycaprolactone (PCL) and polyethylene oxide (PEO) as she...

The viscoelastic properties of the pulmonary parenchyma change rapidly postparturition. We compared changes in mechanical properties with changes in tissue composition of rat lung parenchymal strips in three groups of Sprague-Dawley rats: baby (B; 10-14 days), young (Y; approximately 3 wk), and adult (A; approximately 8 wk). Strips were suspended in an organ bath, and resistance (R), elastance ...