The change in near-tip stress field in Small Scale Yielding (SSY) for cracks located at an interface between two materials with different plastic work hardening is investigated. The difference in hardening is termed hardening mismatch, and is quantified through the parameter n, which is the difference in hardening exponent between the two materials. For cracks in elastic-ideally plastic materia...

Drought stress is the main cause of mortality of holm oak (Quercus ilex L.) seedlings in forest plantations. We therefore assessed if drought hardening, applied in the nursery at the end of the growing season, enhanced the drought tolerance and transplanting performance of holm oak seedlings. Seedlings were subjected to three drought hardening intensities (low, moderate and severe) for 2.5 and ...

Strain hardening capability is critical for metallic materials to achieve high ductility during plastic deformation. A majority of nanocrystalline metals, however, have inherently low work hardening capability with few exceptions. Interpretations on work hardening mechanisms in nanocrystalline metals are still controversial due to the lack of in situ experimental evidence. Here we report, by us...

We present in situ transmission electron microscope tensile tests on focused ion beam fabricated single and multiple slip oriented Cu tensile samples with thicknesses in the range of 100-200 nm. Both crystal orientations fail by localized shear. While failure occurs after a few percent plastic strain and limited hardening in the single slip case, the multiple slip samples exhibit extended homog...

The microstructural evolution during low temperature ageing of two commercial purity alloys (Al1.2Cu-1.2Mg-0.2Mn and Al-1.9Cu-1.6Mg-0.2Mn at.%) was investigated. The initial stage of hardening in these alloys is very rapid, with the alloys nearly doubling in hardness during 20 h ageing at room temperature. The microstructural evolution during this stage of hardening was investigated using diffe...

Based on experimental results, a dislocation material model describing the dynamic strain aging effect at different temperatures is presented. One and two stage loading tests were performed in order to investigate the influence of the loading direction as well as the temperature influence due to the hardening mechanism. Bergström’s theory of work hardening was used as a basis for the model deve...

The present study considers an elastic-plastic contact analysis during loading-unloading of a deformable sphere with a rigid flat using finite element method. The effect of strain hardening on the contact behavior of a nonadhesive frictionless elastic-plastic contact is analyzed using commercial finite element software ANSYS. To study the strain hardening effect different values of tangent modu...