The cracks alter the physical and modal properties of beam, i.e., stiffness, damping, natural frequency, mode shapes, and, in turn, dynamic response beam changes to a considerable extent. condition monitoring beams is essential avoid its catastrophic failure applications. A basic criterion has been followed for parameters like frequencies, stiffness possible crack detection. In contrast, dampin...

Microcantilevers were first introduced as imaging probes in Atomic Force Microscopy (AFM) due to their extremely high sensitivity in measuring surface forces. The versatility of these probes, however, allows the sensing and measurement of a host of mechanical properties of various materials. Sensor parameters such as resonance frequency, quality factor, amplitude of vibration and bending due to...

In this paper a novel RF MEMS cantilever type switch with low actuation voltage is presented. The cantilever beam of switch is supported by two L-shaped springs to reduce the spring constant. The switch is simulated using Intellisuite software. The actuation voltage of switch is achieved about 2 volt and the size of the switch is 110×60μm, that in compared with other electrostatic cantilever be...

We introduce a lateral atomic force microscopy (AFM) method to measure the hydrodynamic drag force acting on a microscopic emulsion droplet moving parallel to a flat surface. A tetradecane oil droplet formed in an aqueous solution of sodium dodecylsulfate was attached to a V-shaped atomic force microscopy cantilever, and lateral hydrodynamic interactions between the droplet and a flat glass sur...

A method for the simultaneous calibration of the spring constants of all flexural modes of microcantilevers is presented. It is based on a flow of gas from a microchannel that interacts with the microcantilever. The gas flow causes a measurable shift in the resonance frequencies of thermal noise spectra of the flexural modes. From the magnitude of the frequency shifts of the individual modes th...

The atomic force microscope can provide information on the atomic-level frictional properties of surfaces, but reproducible quantitative measurements are difficult to obtain. Parameters that are either unknown or difficult to precisely measure include the normal and lateral cantilever force constants (particularly with microfabricated cantilevers), the tip height, the deflection sensor response...