Self-compacting concrete is a fluid mixture suitable for placing in structures with congested reinforcement without vibration. Self-compacting concrete development must ensure a good balance between deformability and stability. Also, compactibility is affected by the characteristics of materials and the mix proportions; it becomes necessary to evolve a procedure for mix design of SCC. The paper...

Effort towards preserving natural coarse aggregate for future generation and reducing cockle shell waste originating from the fisheries industry has initiated studies on possibility of integrating this waste in concrete production. This paper presents the result on the workability and compressive strength of concrete containing various percentage of cockle shell content as partial coarse aggreg...

Sandcrete block, being one of the most important building materials, has become very expensive nowadays and it’s on high demand in Nigeria. In order to reduce its cost and probably increase the compressive strength, this research was conducted to assess the suitability of granite fines as partial replacement for sand in sandcrete block production. The mix proportion (1:6) was used for batching ...

© 2012 IBRACON This paper aims to present the experimental results involving the use of nanoindentation measurements and prediction of macroscale elastic properties of high performance cementitious composites (HPCC). The elastic properties of HPCC mixture were evaluated at different length scales by nanoindentation (microscale), and elastic moduli and compressive strength tests (macroscale). Th...

The strength of Ultra-High Performance Concrete (UHPC) can be sensitively affected by the curing method used. However, in contrast to the precast plant production of UHPC where a standard high-temperature steam curing is available, an optimum curing condition is rarely realized with cast-in-place UHPC. Therefore, the trend of the compressive strength development of UHPC was experimentally inves...

Bricks manufactured from dried sludge collected from an industrial wastewater treatment plant were investigated. Results of tests indicated that the sludge proportion and the firing temperature were the two key factors determining the brick quality. Increasing the sludge content results in a decrease of brick shrinkage, water absorption, and compressive strength. Results also showed that the br...

polymethyl methacrylate (pmma), widely used as a prosthodontic base, has many disadvantages, including a high thermal expansion coefficient and low thermal conductivity, a low elasticity coefficient, low impact strength and low resistance to fatigue. this study aimed to make an in vitro comparison of the thermal conductivity, compressive strength, and tensile strength of the acrylic base of com...

agricultural waste fibers have been found to be suitable as reinforcement in cement-based composites, but studies on oil palm fiber as reinforcement in gypsum-cement wall panels are scarce. a mixture of two equal weights of gypsum and cement, with water-binder ratios of 0.45 and 0.55 were prepared. in each mix a varying percentage of fiber contents of 2%, 3% and 4% by weight of the binders were...

cementing is an essential part of every drilling operation. protection of the wellbore from formation fluid invasion is one of the primary tasks of a cement job. failure in this task results in catastrophic events, such as blow outs. hence, in order to save the well and avoid risky and operationally difficult remedial cementing, slurry must be optimized to be resistant against gas migration phe...