dissimilar metals friction welding of austenitic–martensitic stainless steels is commonly used in order to manufacture engine valves in the automobile industry. in this study, x53crmnnin219 (austenitic stainless steel) and x45crsi93 (martensitic stainless steel) valve steel rods were welded by friction welding process. the welded joint was then heat treated at 760 0c for 60 min. mechanical prop...

Present study focuses on the micro-structural and mechanical behavior effect of friction time for similar (AISI 316-AISI 316 and AISI 304-AISI 304) and dissimilar (AISI 304-AISI 316) joint during continuous drive friction welding. The welding carried out with different friction time: 6.5, 8.5 and 10 s while kept all other conditions constant. The effect of that time on the strength, structural ...

For hot extrusions of magnesium alloy sheets, Dissimilar AZ80 and AZ31 were used, in which AZ80 was placed on advancing side and AZ31 on retreating side, using friction stir butt welding with different process parameters. Some defect-free welded joints with good weld surfaces could be obtained with some suitable welding conditions. The maximum tensile strength of welded joint which is 225.5 MPa...

Z. Burzić, Military Technical Institute, Belgrade, Serbia. Dž. Gačo, F. Islamović, E. Bajramović, Technical faculty, University of Bihac,Bihac, Bosnia and Herzegovina. M. Burzić, University of Belgrade, I.C. Faculty of Mechanical Engineering, Belgrade, Serbia. In present paper, experimental investigations have included the eff ect of exploitation conditions (exploitation time and temperature) o...

R. Bakić, Tutin High School, Serbia, M. O. Abukresh, A. Sedmak. Faculty of Mechanical Engineering, University of Belgrade, Serbia, I. Samardžić, Faculty of Mechanical Engineering, Slavonski Brod, University of Osijek, Croatia, R. Jovičić, Innovation centre of the Faculty of Mechnical Engineering, Belgrade, Serbia Complex microstructure of austenite-ferrite welded joint has been investigated, fo...

Welding involves a metallurgical union process that relies on base metal fusion, i.e. the constituent metal of the structure, with or without filler metal, to form the soldered joint. Thus, a definition of welding proposed by the AWS is an "operation which aims to get localized coalescence produced by heating to a suitable temperature, with or without applying pressure and filler metal, produci...

Determination of stress strain state components of butt welded joint with a mild interlayer at elasto-plastic tension is presented in this paper. Function of normal transverse stresses distribution on the thickness of mild interlayer and equations for determination of the stress intensity maximum value in hard metal at elasto-plastic deforming are proposed. The longitudinal stresses of mild and...

This paper deals with an experimental investigation on the friction stir welding of pure copper. 4 mm thick copper plates have been welded in the butt joint configuration using a conical unthreaded tool, with and without preheating. An electrically heated backing plate has been employed to increase the initial temperature of the plates and to investigate the influence of pre-heating on the weld...

This paper summarizes fatigue test on high strength steel specimens in the as-welded condition and specimens treated by ultrasonic impact treatment, TIG dressing and a combination of TIG dressing and ultrasonic impact treatment. Single lap joint specimens in 6 mm aluminium plate material were tested in the as-welded, hammer peened, needle peened and ground condition. Aluminium joints with longi...