Applying corona wind as a novel technique can lead to a great level of heat and mass transfer augmentation by using a very small amount of energy. The enhancement of forced flow evaporation rate by applying electric field (corona wind) has been experimentally evaluated in this study. Corona wind produced by a fine wire electrode charged with positive high DC voltage impinges on water surface an...

Dense urban areas restrict air movement, causing airflow in urban street canyons to be much lower than the flow above buildings. Boosting near-ground wind speed can enhance thermal comfort in warm climates by increasing skin convective heat transfer. We explored the potential of a wind catcher to direct atmospheric wind into urban street canyons. We arranged scaled-down models of buildings with...

in this study, changes in speed and turbulence intensity in the wake of a peugeot model and the drag coefficient changes with increases vehicle speed in unsteady flow measured and evaluated. the blow open circuit wind tunnel to simulate fluid flow is used. disturbances and nominal maximum speed of the device, respectively is, 30 m / s and 0.01%. has been continuously increasing speed by an inve...

Chandler et al. [COJ15] presented interpolation-based pathline tracing as an alternative to numerical integration for advecting tracers in particle-based flow fields and showed that their method has lower error than a numerical integration-based method for particle tracing. We seek to understand the sources of the error in interpolation-based pathline tracing. We present a formal analysis of th...

The rapid expansion of wind power generation has brought problems involving lightning strikes to the fore. Many such incidents have damaged not only the wind turbine that was actually struck, but also other turbines that were not. The phenomenon of surge invasion to the distribution line is categorized as “back-flow surge”. It has been reported that this back-flow surge sometimes burns out surg...

Transient responses of sap flow to step changes in wind speed were experimentally investigated in a wind tunnel. A Granier-type sap flow sensor was calibrated and tested in a cylindrical tube for analysis of its transient time response. Then the sensor was used to measure the transient response of a well-watered Pachira macrocarpa plant to wind speed variations. The transient response of sap fl...

A boundary layer wind tunnel facility has been adopted in order to conduct experimental measurements of the flow field around a model of the Panorama Giustinelli Building, Trieste (Italy). Information on the main flow structures has been obtained by means of flow visualization techniques and has been compared to the numerical predictions of the vortical structures spread on top of the roof, in ...

The reliable measurement of pressures on low-rise buildings in the atmospheric boundary layer (ABL) flow remains a challenge, as has been shown by the large discrepancies among results obtained in different wind tunnel facilities or even in the samewind tunnel. Twomajor causes of the discrepancies are the difficulty of simulating large-scale, low-frequency turbulent fluctuations uniformly acros...

in a steam power plant, the temperature of the cooling water leaving the condenser for recyclingshould decrease. this is achieved in a cooling tower. the heller cooling tower does not require waterfor operation, thus, it is a suitable system for use in thermal power plants throughout iran. wind is anenvironmental factor that unfavorably affects the performance of a cooling tower. previous studi...