Fluoride removal from water is being investigated using a natural adsorbent derived from bark of pinus kesiya. Batch studies were performed to study the effect of adsorbent dose, contact time, initial fluoride concentration and pH on the removal efficiency. The fluoride adsorption varies over wide range of pH and best in between 3 – 8. The rate of adsorption was rapid and maximum removal took p...

Animal bone charcoal (ABC) produced from animal bones was used as adsorbent to remove Cr(VI) from its aqueous solution . Labority experimental investigation was carried out to identify the effect of contact of time, pH, adsorbent dose and initial concentration on the adsorption of chromium from metal solution. Results showed that pH 2 was the most suitable, while the removal of Cr(VI) ions with...

Sawdust a timber waste has been used as a bio-sorbent for the removal of a cationic dye, malachite green from aqueous solutions. The process of removal has been optimized for different parameters like initial concentration of dye solution and contact time, pH, adsorbent dose, and temperature. pHzpc of the adsorbent was determined. Elemental analysis of the adsorbent was carried out. FTIR was pe...

Crofton weed stalk (CWS) was used as an adsorbent to remove methylene blue (MB) from aqueous solution. The adsorbent was analyzed by FT-IR and observed by SEM. The porosity and pHzpc were measured. The effects of adsorbent dose, initial dye concentration, solution pH, and solution temperature were investigated. Models of the adsorption kinetics and isotherms were analyzed, and thermodynamic par...

This paper present the possible alternative removal options for the development of safe drinking water supply in the arsenic-affected areas. Each alternative option was studied in the Environmental Engineering Laboratory at Indian Institute of Technology (IIT) Kharagpur, India. In this paper conventional precipitation (Alum and Iron salt) and adsorption (With various types of adsorbent) method ...

At this work, removal of Pb (II) using Lawsonia inermis (Henna) was studied. In recent years, use of low price adsorbent is taken into consideration. Adsorption experiments were performed in batch system at ambient temperature (25℃). The influence of some parameters such as time, initial metal concentration, pH and adsorbent dose were investigated. The optimum conditions was obtained at pH of 6...

Sawdust is obtained from naturally and easily available which is biodegradable. The bio sorption capacity of the sawdust for hexavalent chromium was studied at different solution pH values (1.5-6), initial metal concentration (50450 mg/L), adsorbent dose (1-7 g/L). The maximum adsorption of Cr (VI) is obtained at pH 1.5, initial concentration 50 ppm and adsorbent dose 5 g/l. The adsorption of c...

The adsorption potential of iron acetate coated activated alumina (IACAA) for removal of arsenic [As (III)] as arsenite by batch sorption technique is described. IACAA was characterized by XRD, FTIR, EDAX and SEM instruments. Percentage adsorption on IACAA was determined as a function of pH, contact time and adsorbent dose. The study revealed that the removal of As (III) was best achieved at pH...

Organic pollutants have an adverse effect on the neighboring environment. Industrial activates are the major sources of different organic pollutants. These primary pollutants react with surrounding and forms secondary pollutant, which persists for a long time. The present investigation has been carried out on the surface of activated sawdust for phenol eliminations. The process parameters initi...

This study deals with the enhancement of chromium (VI) removal by vacuum drying and plasma pre-treatments of cocolumber (Cocos nucifera) sawdust. For fixed adsorbent dose and pH, the effects of important parameters such as initial adsorbate concentration and contact time are determined. Results show that both pre-treatments increased the adsorption efficiency of the sawdust. The adsorption data...