In this study, energy and exergy analysis were performed for a single cylinder, water-cooled diesel engine using biodiesel, diesel and bioethanol blends. Each experiment was performed at twelve different engine speeds between 1000 and 3000 rev/min at intervals of 200 rev/min for four different fuel blends. The fuel blends, prepared by mixing biodiesel and diesel in different proportions fuel wi...

Exergy is precious energy. On the basis of thermodynamic analysis of thermal processes, one can choose more exergy-saving devices. This is especially important in refrigeration processes, in which the consumption of energy and exergy increases considerably with the falling cooling temperature. The exergy efficiency in terms of exergy losses of vapour compression and sorption cooling processes i...

This paper reports a plenary thermodynamic model of a novel solar system for water heating in buildings. Energy and exergy analyses are used to characterize the exergy destruction rate in any component and calculate system overall efficiency. The system consists of a solar evaporator, a heat exchanger to produce hot water, and an auxiliary pump. A computer simulation program using EES software ...

This study is part 2 of the investigation on exergetic and exergoeconomic parameters an existing system with air-to-water heat pump unit as a source. Part 1 presents used experimental setup. The main aim conducted tests to develop models produced rate energetic COP at different ambient conditions. obtained data in where exergetinc assessment carried out. analysis was performed dynamically chang...

The aeroderivate gas turbines are widely used for power generation in the oil and gas industry. In offshore marine platforms, the aeroderivative gas turbines provide the energy required to drive mechanically compressors, pumps and electric generators. Therefore, the study of the performance of aeroderivate gas turbines based on a parametric analysis is relevant to carry out a diagnostic of the ...

This study presents comparative energy and exergy analyses of a four-cylinder, four-stroke spark-ignition engine using gasoline fuels of three different research octane numbers (RONs), namely 91, 93 and 95.3. Each fuel test was performed by varying the engine speed between 1200 and 2400 rpm while keeping the engine torque at 20 and 40Nm. Then, using the steady-state data along with energy and e...

Thermal energy storage is attractive in the design of concentrator solar thermal systems because of its ability to increase turbine capacity factor and to facilitate dispatchable, if not continuous, power output from a solar field. At the right cost, a storage system can improve overall economics of a solar energy system. Presented here is a simulation study of the performance of a cycle that u...