Uncoated surfaces of high index glasses when cemented to form lens doublets have inferior antireflection properties to doublets of low index glass. This can be overcome by the application of a single layer coating of aluminum oxide prior to cementing.

The electrochemical properties of fluoride-coated lithium cobalt oxide [LiCoO2] thin films were characterized. Aluminum fluoride [AlF3] and lanthanum fluoride [LaF3] coating layers were fabricated on a pristine LiCoO2 thin film by using a spin-coating process. The AlF3- and LaF3-coated films exhibited a higher rate capability, cyclic performance, and stability at high temperature than the prist...

The kinetic of the heterogeneous chemical reaction of aluminum hydroxide and fluosilicic acid was studied. It was found that the diffusion of the reactants through the porous silica coating to the aluminum hydroxide surface and the interfacial chemical reaction between the diffusing reactant and aluminum hydroxide platelets control the overall reaction rate. These two phenomena were studied...

The isothermal oxidation resistance of Al0.2Co1.5CrFeNi1.5Ti0.3 high-entropy alloy is analyzed and the microstructural evolution of the oxide layer is studied. The limited aluminum, about 3.6 at %, leads to the non-continuous alumina. The present alloy is insufficient for severe circumstances only due to chromium oxide that is 10 μm after 1173 K for 360 h. Thus, the aluminized high-entropy allo...

Open-celled aluminum foams with different pore sizes were fabricated. A plasma electrolytic oxidation (PEO) treatment was applied on the aluminum foams to create a layer of ceramic coating. The sound absorption coefficients of the foams were measured by an impedance tube and they were calculated by a transfer function method. The experimental results show that the sound absorption coefficient o...

The fully-leaky guided wave technique has been used to study the reflective 90 ̊ MTN liquid crystal cell used for LCOS. The cell is comprised of upper substrate with indium-tin-oxide coating and lower substrate with aluminum coating. Reflective angle-dependent signals (Rss, Rpp, Rsp and Rps) were recorded over a range of angles of incidence with the cell under application of 0 7 Vrms ac electric...

Epoxy coatings incorporating different content of sulfosalicylic acid doped polyaniline (PANI-SSA) have been investigated for corrosion protection of 5083 aluminum alloy in 3.5% NaCl solution. The performance of the coatings is studied using a combination of electrochemical impedance spectroscopy (EIS), open circuit potential (OCP), gravimetric tests, adhesion tests, scanning electron microscop...

The purpose of this investigation was to develop a coating technique and to study the characteristics of titanium–aluminum nitride [(Ti,Al)N] films deposited on a base-metal alloy (Wiron88R) substrate. Titanium–aluminum nitride thin films were deposited on the alloy surface using a reactive radiofrequency sputtering method. The electrochemical properties of three specimens with and without coat...

Corrosion is the degradation or deterioration of metal components due to a reaction with the environment. Chromate conversion coating is applied to passivate metallic surface to slow down (and prevent to some extent) corrosion process. Chromate conversion process uses chromium compounds including hexavalent chromium, which is toxic, carcinogenic and hazardous to human health and environment. He...

In the aluminum die casting process, erosion, corrosion, soldering, and die sticking have a significant influence on tool life and product quality. A number of coatings such as TiN, CrN, and (Cr,Al)N deposited by physical vapor deposition (PVD) have been employed to act as protective coatings due to their high hardness and chemical stability. In this study, the wear performance of two nanocompo...