Ash deposition on heat transfer surfaces is still a significant problem in coal-fired power plant utility boilers. The effective ways to deal with this problem are accurate on-line monitoring of ash fouling and soot-blowing. In this paper, an online ash fouling monitoring model based on dynamic mass and energy balance method is developed and key variables analysis technique is introduced to stu...

using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. in this work two-dimensional incompressible laminar flow of a nanofluid e...

sometimes the need for non-circular ducts arises in many heat transfer applications because of lower pressure drop of non-circular cross section such as square duct compared to circular tube, particularly in compact heat. but square cross section has poor heat transfer performance and it is expected that using a nanofluid as a new heat transfer media may improve the heat transfer performance of...

certain gases, principally oxygen,o , and carbon dioxide, co , dissolved in water accelerate its corrosive properties. the rate of corrosion is approximately in prportion to the quantity of gas dissolved. the removal of gases from water, as practiced in steam station, is effected by mechanical and thermal treatment , by addition of chemicals, or by combinations of these processes, the most wide...

abstract: in this study, al 2 o 3 /eg and tio 2 /eg nanofluids as coolants have been used in the double-tube heat exchanger. the hot solvent inlet heat exchanger must be cooled down with a specified amount. we can use nanofluids as coolants in the heat exchanger for optimization of the heat transfer area. therefore, the efficacy of nanofluids as coolants is verified. furthermore, flow rate of c...

This paper focuses on the simulation and visualisation of coal combustion in the pulverised coal boilers. It is important to find optimal boiler configurations (both for the ecological and economical reasons), determine appropriate combustibles, optimize process of combustion, etc. These tasks are typically solved using traditional Computational Fluid Dynamics (CFD) methods that are in general ...

The objective of this paper was to design energy integrated solid oxide fuel cell (SOFC) based microcombined heat and power (micro-CHP) systems using syngas derived from lignocellulosic biomass waste. The novel contributions of this work include 1) integration of syngas between a community-scale biomass gasification plant and SOFC based micro-CHP systems in buildings; 2) heat integrated designs...

in this paper by the introduction of the basic equipment of a solar cooling system, solar hydrogen ammonia refrigeration system as a solar cooling technique will be discussed. using heat collector and absorption refrigeration allows us to use residual heat, for cooling, heating and producing hot water and boiling water .this research focuses on methods of heat transfer from the sun into the gen...