Strength tests on single lap joints with one adhesive (AV138/HV998) and layer thickness (0.5 mm), three peel stoppers (brass bolt, nylon bolt steel pin), four lengths (12.5 mm, 25 40 mm 100 mm) were conducted to investigate the effects of varying length stiffness peel-stop fasteners. Joint failure stress decreased, but force increased length. Furthermore, joint was higher stopper. The effect br...

accumulative roll-bonding (arb) is a severe plastic deformation process that is using rolling to produce ultrafine grains in coarse grained metallic materials. in this study, arb has been applied on 70/30 brass up to 6 cycles at ambient temperature and non-lubricated conditions to apply a true strain up to 4.8 von mises strain. microstructures of arbed brass samples were characterized by scanni...

Cu-Zn alloys have been electrodeposited from a pyrophosphate electrolyte containing Cu2P207> Zn2P207 salts and an excess of K4P2O7 and KN03. Current-potential data for both copper and zinc, as well their plating current efficiencies were determined from electrochemical polarisation experiments. Copper deposition commenced at potentials below -0.208 V whereas zinc was deposited only below -1.157...

We present a framework for expressing bottom-up algorithms to compute the well-founded model of non-disjunctive logic programs. Our method is based on the notion of conditional facts and elementary program transformations studied by Brass and Dix in (Brass & Dix, 1994; Brass & Dix, 1999) for disjunctive programs. However, even if we restrict their framework to nondisjunctive programs, their “re...

Brass instruments and the human voice production system are both composed of a vibrating "human valve" (constriction in a pipe) coupled to an acoustic resonator: lips coupled to the brass instrument or vocal folds coupled to the vocal tract. In both cases, the aeroacoustic coupling is responsible for the self-oscillations and a large variety of regimes. Additionally, brass instruments and voice...

Figure 1. Spray gun used in electron microscopy. A. Assembled spray gun. B. Outer envelope. C. Insert tube. The component parts have the following specifications: 1. Nozzle head X inch threads, 0.030 inch aperture. 2. "O" ring, Y8 inch outside diameter (o.d.) and Y inch inside diameter (i.d.). S. X8 inch threads, tapered end. 4. Brass tubing %6 inch o.d.; 0.035 inch wall. .946 inch threads, mov...

A target changeable palm-top size x-ray tube was realized using pyroelectric crystal and detachable vacuum flanges. The target metals can be exchanged easily by attaching them on the brass stage with carbon tape. When silver and titanium palates (area: 10 mm(2)) were used as targets, silver Lα and titanium K lines were clearly observed by bombarding electrons on the targets for 90 s. The intens...

the brass tubes with foam cores of alsi7sic3, alsi7sic3fe1 and alsi7sic3fe3 were produced as the crush-boxes with circle and square cross-section. then axial compressive behavior and energy absorption capability of the foam-filled tubes were investigated during the quasi-static progressive plastic buckling. the uniaxial compressive stress–strain curves of the foam-filled brass tubes exhibited t...