Low carbon ferritic steel alloyed with Ti, Mo and Cu was hot rolled and interrupt cooled to produce nano-sized precipitates of copper and (Ti,Mo)C carbides. The steel had a tensile strength of 840 MPa, an increase in yield strength of 380 MPa over that of the plain carbon steel and reasonable ductility. Transmission electron microscopy and small angle neutron scattering were used to characteriz...

The evaporation of inertial confinement fusion first wall materials from unattenuated pellet X-rays and from radiation emitted by a cavit.y buffer qas is examined. The low vapor pressure and low X-ray attenuation coefficient of carbon give it a lower erosion rate than stainless steel, despite the larger thermal conductivity of Type 316 stainless steel. For the argon buffer gas containing 0.2% N...

Three low-carbon bainitic steels were designed to investigate the effects of Cr and Al addition on bainitic transformation, microstructures, and properties by metallographic method and dilatometry. The results show that compared with the base steel without Cr and Al addition, only Cr addition is effective for improving the strength of low-carbon bainitic steel by increasing the amount of bainit...

a low carbon al-killed ti-added steel was produced in mobarakeh steel complex in iran. mechanical properties and microstructural characterizations of steel in the as-cast, hot-rolled, cold-rolled and annealed conditions are presented. dilatometery tests were carried out to measure the finishing and annealing temperatures of steel. it was found that the addition of small amounts of ti increased ...

advanced high strength steels (ahss) have recently attracted great attention because of their superior mechanical properties. a modern group of these steels, known as twinning induced plasticity (twip) steels, shows a unique combination of strength and ductility even at high rates of strain. in order to examine the functionality of such steels in dynamic loading conditions, their mechanical beh...

The objective of this research is to estimate location and size using laser ultrasound guided wave for wall thinning evaluation of elbow. Wall thinning of carbon steel pipe is one of the most serious problems in Nuclear Power Plant especially wall thinning of carbon steel elbow caused by FAC (Flow-Accelerated Corrosion). Therefore non-destructive inspection method of elbow is essential for safe...

in this investigation, attempts were directed to study the inhibitive effects of nitrite and phosphate base inhibitors for the carbon steel alloy samples, which are used in an acid gas treatment process (the sulfiran® solution), in fe-edta solution. electrochemical techniques, i.e. polarization curves and electrochemical impedance spectroscopy (eis), were used to evaluate the inhibition efficie...

using c2h2, 112 and as gases at 550'c, carbon nanotubes were fabricated on the surfaces of twosubstrates coated by nano thin layers of metal catalysts by dc magnetron sputtering. aystamless steel andfe/cteal, by thermal chemical vapor deposition (tcvd) the surface properties of the substrates wereparticularly investigated, and the effect of treatment of the substrates on the cnt's growth is cri...

the lack of complete understanding of the substrate effects on carbon nanotubes (cnts) growth poses a lot oftechnical challenges. here, we report the direct growth of nanostructures such as the cnts on stainless steel 304and brass substrates using thermal chemical vapor deposition (tcvd) process with c2h2 gas as carbon sourceand hydrogen as supporting gas mixed in ar gas flow. we used an especi...

The life of a concrete bridge exposed to deicing salt or seawater has often been limited by corrosion of the steel reinforcement. The service life of a concrete structure, degraded by corrosion, is considered to be the sum of the initiation and propagation periods. The initiation phase is the time required for sufficient accumulation of aggressive species at the rebar surface to initiate corros...