In the paper we rewiev the experience with the steel from Cold Rolling Mill Kraluv Dvur near Prague, where the steel for barrel module 0 prototype of the TILECAL calorimeter was fabricated. The measurements of the tolerances, mechanical properties and the chemical composition are presented.

In this paper an analysis is done on the main drive of rolling mill which consumes about 60 to 70 % of total energy of the plant. The existing rolling mill in India are using the 3 phase induction motor and flywheel to drive the rolling mill. The electric motor transmits the power to flywheel with the help of V-belt. An attempt has made after analysis of existing mill that by using some soft st...

Flatness measurement using shape-rolls has been used in cold rolling mills for a long time. The benefit is obvious since the measured flatness profile can be used directly to control roll bending, tilt and cooling profile. It was therefore integrated in the mill control system at an early stage to control the strip shape against a target I-unit profile. However, since the flatness is also affec...

Abstract Intermediate roll shifting (IRS) is widely used for improving the strip shape in six-high tandem cold mill, but most related studies are limited to a single stand. To fill knowledge gap, three-dimensional (3D) multi-stand elastic–plastic finite element (FE) model was developed continuously variable crown (CVC)-6 mill using data transfer, which then validated by industrial experimental ...

The purpose of the hot rolling mill is to make a preheated steel block thinner and longer, see Figure 1. This is done by pulling the plate through two parallel rolls mounted in the rolling mill. Due to the large forces obtained in hot rolling, the elastic de ection of the rolling mill is of the same order of magnitude as the plate thickness. Variations in the rolling force caused by variations ...

Based on the stochastic rolling force data from aluminum hot strip tandem mill, the ARMA time series model and the stochastic excitation power spectral density (PSD) model are established, and the stochastic rolling forces excitation model is established by utilizing Levenberg-Marquardt combined with generalized global planning algorithm. A two dimensional stochastic nonlinear dynamical model o...