A numerical model is developed to simulate the transport phenomena in the flow channel between parallel plates with porous and non-porous (or impermeable) walls. The continuity and momentum equations were solved first, assuming the wall Reynolds number in the range of with the suction or injection of air at a speed equal to the uniform inlet velocity. The results show that at constant inlet and...

the thermo-hydraulic behavior of the air flow over a two dimensional ribbed channel wasnumerically investigated in various rib-width ratio configurations (b/h=0.5-1.75) atdifferent reynolds numbers, ranging from 6000 to 18000. the capability of differentturbulence models, including standard k-ε, rng k-ε, standard k-ω, and sst k-ω, inpredicting the heat transfer rate was compared with the experi...

Laminar mixed convection of Aluminium oxide (Al2O3)–water nanofluid flow in an inclined annulus using a single-phase approach was numerically studied. Constant heat flux boundary conditions were applied on the inner and outer walls. All the thermophysical properties of nanofluid, such as, viscosity, heat capacity, thermal conductivity, and thermal expansion coefficient...

The Galerkin finite element method is used to solve the three dimensional continuity, momentum and energy equations for laminar Newtonian and power-law model non-Newtonian flow through horizontal circular tube. The governing equations are non-dimensionalized with respect to specific variables and converted into algebraic equations using appropriate elements. To accelerate convergence a combinat...

We investigate the velocity dependence of the friction between two rigid blocks limited by a self-affine surface such as the one generated by a crack. The upper solid is subjected either to gravity or to an extemal elastic stiffness, and is driven horizontally at constant velocity, V, while the lower solid is fixed. For low velocities, the apparent friction coefficient is constant. For high vel...

Vortex extrusion (VE) is a severe plastic deformation technique which is based on the synergies between high strain accumulation and high hydrostatic pressure. Such a high amount of pressure, places a mandate to seek the method for investigation of the load under processing conditions. For this, kinematically admissible velocity field and upper bound terms based on Bezier formulation are develo...

Friction and wear are detrimental to engineered systems. Ultrasonic lubrication is achieved when the interface between two sliding surfaces is vibrated at a frequency above the acoustic range (20 kHz). As a solid-state technology, ultrasonic lubrication can be used where conventional lubricants are unfeasible or undesirable. Further, ultrasonic lubrication allows for electrical modulation of th...

Laminar mixed convection of Aluminium oxide (Al2O3)–water nanofluid flow in an inclined annulus using a single-phase approach was numerically studied. Constant heat flux boundary conditions were applied on the inner and outer walls. All the thermophysical properties of nanofluid, such as, viscosity, heat capacity, thermal conductivity, and thermal expansion coefficient, except density in the bo...

A dilute gas of particles with short range interactions is considered in a shearing stationary state. A Gaussian thermostat keeps the total kinetic energy constant. For infinitely many particles it is shown that the thermostat becomes a friction force with constant friction coefficient. For finite number of particles N, the fluctuations around this constant are of order 1/squareroot[N], and dis...

a numerical model is developed to simulate the transport phenomena in the flow channel between parallel plates with porous and non-porous (or impermeable) walls. the continuity and momentum equations were solved first, assuming the wall reynolds number in the range of with the suction or injection of air at a speed equal to the uniform inlet velocity. the results show that at constant inlet and...