The problem of control associated wind energy conversion systems using horizontal-axis fixed-pitch variable speed low-power, working in the partial load region, consisting in the energy conversion maximization, is approached here under the assumption that the wind turbine model and its parameters are poorly known. Intelligent gradient detection method by using Maximum Power Point Tracking (MPPT...

The excursion of maximum power point always exists due to nonlinear and time-varying characteristics of photovoltaic (PV) generation. To solve this problem, the maximum power point tracking (MPPT) control strategy based on generalized predictive control (GPC) is put forward. Firstly, the theory and feature of PV cell is analyzed, and the MPPT control model is constituted based on Boost circuit....

This paper presents a fuzzy controller (FC)based single-ended primary-inductor converter (SEPIC) for maximum power point tracking (MPPT) operation of a photovoltaic (PV) system along with battery. The FLC proposed scheme uses the convergent distribution of the membership function. The fuzzy controller for the SEPIC MPPT scheme shows the voltage without any changes in different load conditions a...

Photo voltaic based distributed generation system has seen a wide spread interest in research community because of growing energy needs. For efficient distributed generation system, a PV cell is connected with a DC-DC converter and DC-AC inverter. Maximum power point tracking (MPPT) algorithm is used to extract maximum power from the PV cell. There are different MPPT algorithms such as perturb ...

In this paper, we present and demonstrate a rotational energy harvester with a component-optimised maximum power point tracking (MPPT) circuit for adaptive power conversion. An AM-transmitter and receiver was used to instrument the harvester during operation. Experimental results on the effects of current limiting the harvester and the end-to-end efficiency of the MPPT circuit are shown. Finall...

This paper presents an efficient maximum power point tracking (MPPT) controller for a standalone photovoltaic (PV) generation system. To achieve an efficient MPPT controller, a new boost converter design and an improved MPPT algorithm are incorporated. In the proposed boost converter design, a passive regenerative snubber circuit is included to absorb the energy of stray inductance so as to red...

In this paper, a fuzzy-logic-control (FLC) based maximum power point tracking (MPPT) algorithm for photovoltaic (PV) systems is proposed. The power variation and output voltage variation are chosen as inputs of the proposed FLC, which simplifies the calculation. Compared with the conventional perturb and observe (P&O) method, the proposed FLC-based MPPT can simultaneously improve the dynamic an...

This paper focuses on the implementation of a three-phase four wire current-controlled Voltage Source Inverter (CC-VSI) as both PV energy extraction and power quality improvement. For power quality improvement, the CC-VSI works as a grid current-controller shunt active power filter. Then, the PV array supported by a Look-up Table type of a MPPT controller is coupled to the DC bus of the CC-VSI....

Received Sep 15, 2017 Revised Nov 14, 2017 Accepted Nov 23, 2017 In this paper, a straightforward strategy for tracking the maximum power (MP) accessible in the wind energy conversion system for dc microgrid is proposed. A three-phase diode bridge rectifier alongside a dc-dc converter has been utilized between the terminals of wind-driven induction generator and dc microgrid. Induction generato...