ISSN: 2319-1112 /V2N2:243-248 ©IJAEEE Abstract : To increase the processing speed and decrease the power consumption, the operating voltages of computer microprocessors is reduced below 1.5V. At the same time, it is expected that these processors will require much more current. To keep the distribution losses low at an increased power level, the input current of the new generation of on-board d...

− This article presents further testing and verification results for a previously introduced new intelligent regulation method that controls the power-electronic Buck converter utilizing a small-signal model of the pulse width modulation (PWM) switch. The implemented intelligent control method uses a fuzzy-PID controller that is tuned using the global search method of genetic algorithm (GA). Th...

This paper deals with the modeling of bond graph buck converter systems. The bond graph formalism, which represents a heterogeneous formalism for physical modeling, is used to design a sub-model of a power MOSFET and PiN diode switchers. These bond graph models are based on the device’s electrical elements. The application of these models to a bond graph buck converter permit us to obtain an in...

Keywords: DC-DC buck converter, Fast transient response, Fuzzy logic controller (FLC). A new low output voltage and fast transient response dc-dc converter is designed in order to feed devices such as microprocessors and DSPs. It is a fast response DC-DC buck converter (FRBC) comprising of two buck converters connected in shunt and controlled by Fuzzy logic controller. First the Linear Control ...

This paper presents a transformer less ac/dc converter which can be used in voltages between 90230 Vrms. Instead of a transformer, this topology consists of a buck dc/dc converter and a buck boost dc/dc converter. By the absence of transformer, reduce the complexity of converter and it is cost effective. Buck dc/dc converter keeps o/p voltage below the line voltage; limit the leakage current. B...

A novel modified bridge-type dual input DC-DC converter, which is proficient for integrating distinct V-I characteristic sources such as solar-PV, wind, etc., and storages including battery, ultracapacitor, fuel cell, etc., is proposed in this paper. Three modes of operations such as boost, buck, and buck-boost are possible using the same structure of the converter, and the converter can operat...

This paper shows the results of adding static converters (Boost, Buck and Buck-Boost converters) as an adaptation solution between a PEM Fuel Cell generator and a resistive load in order to study different effects of the converter on the generator performances in terms of voltage and current behavior. The presented results are obtained by simulating the Bond Graph developed model under 20-Sim s...

Abstract – Resonant parametric perturbation (RPP) method is an effective non-feedback method for controlling chaos. In this paper, the above method is applied for the current programmed buck-boost dc-dc converter which exhibits chaotic for wide parameter variations. The different possible operating regimes leading to chaotic operation of the current mode controlled buck-boost converter is discu...

The neutral beam injection generate ultra-high temperature energy in the tokamak of nuclear fusion. The neutral beam injection make up arc power supply, filament power supply and acceleration & deceleration power supply. The arc power supply has characteristics of low voltage and high current. Arc power supply generate arc through constant output of voltage and current. So this paper proposed s...

The paper focuses on a DC/DC converter that is used to adapt a varying output voltage from a solar panel to demands of an electrolyzer unit or battery charging purposes. The converter covers an input voltage span from 9 V to 24 V and has an output voltage of 12 V at a maximum current of 50 A. A modular topology of the converter is described along with a microcontroller control strategy. Finally...