agricultural products are affected by static and dynamic forces at different stages of harvesting, handling and processing. in most cases, the damages are inflicted upon raw products. in the present study the mechanical properties of tomato fruits were found out for two cultivars (super bta and petoerly ch), during 4 periods of time (1, 5, 10 and 15 days past harvest), and at two levels of frui...

deflection analysis of a simply supported microbeam subjected to a concentrated load at the middle is investigated on the basis of a shear deformable beam theory and non-classical theory. effects of shear deformation and small size are taken into consideration by hyperbolic shear deformable beam theory and modified strain gradient theory, respectively. the governing differential equations and c...

This paper presents a method for effectively modeling the outer surfaces of inlay/onlay prostheses restoring teeth that are partially destroyed. We exploit 3D mesh deformation techniques: direct manipulation free-form deformation (DMFFD) [9] and multiple wires deformation (MWD) [10] with three kinds of information: standard teeth models, scanned mesh data from the plaster cast of a patient's to...

Parallel tubular channel angular pressing (PTCAP) process is a novel recently developed severe plastic deformation technique for fabrication of ultrafine grained (UFG) metallic tubes. This new process consists of two half cycles and is affected by several parameters such as channel angles, deformation ratio and curvature angles. In this paper, the effects of these parameters on the plastic defo...

frequency response analysis (fra) is popular technique which has been used since the last decade as a diagnostic method for transformers. however, accurate interpretation of fra measurements is still challenging. recent studies reveal that apart from winding deformation, fra data can also be influenced by moisture variation in transformer paper insulation. hence, a specific transformer’s model ...

A common approach for the analysis of anatomical variability relies on the estimation of a representative template of the population, followed by the study of this population based on the parameters of the deformations going from the template to the population. The Large Deformation Diffeomorphic Metric Mapping framework is widely used for shape analysis of anatomical structures, but computing ...

the built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. the built up layer (bul) is formed in second deformation zone near the tool-chip interface in the back of the chip. this parameter influences the tool life and machined surface quality. this bul should not be confused with the built up edge (bue). the deformation of the bul in...

In the present study, the microstructural changes of a Nickel based superalloy Nimonic80A during a non-isothermal deformation were studied. Therefore, microstructure evolutionduring hot side pressing test was predicted with combined methods of finite element analysis andprocessing map of the material. The predicted results were validated through experimentalmicrostructural studies. The results ...

There are mainly two methods of deep drawing analysis; experimental and analytical/numerical. Experimental analysis can be useful in analyzing the process to determine the process parameters that produce a defect free product, and the analytical/numerical modeling can be used to model and analyze the process through all stages of deformation. This approach is less time consuming and more econom...

this research intends to develop a method based on the artificial neural network (ann) to predict permanent earthquake-induced deformation of the earth dams and embankments. for this purpose, data sets of observations from 152 published case histories on the performance of the earth dams and embankments, during the past earthquakes, was used. in order to predict earthquake-induced deformation o...