the constitutive relationships of the rubber materials that act as the main spring of a hydraulic engine mount are nonlinear. in addition to material induced nonlinearity, further nonlinearities may be introduced by mount geometry, turbulent fluid behavior, temperature, boundary conditions, decoupler action, and hysteretic behavior. in this research all influence the behavior of the system only...

Ah&act-The tem~ratu~-de~ndent thermal expansivities of melts along the join ano~hite-diopside have been determined on glassy and liquid samples using a combination of calorimetry, dilatometry, and Pt double bob Archimedean densitometry. Supercooled liquid volumes and molar thermal expansivities were determined using scanning calorimetric and dilatometric measurements of properties in the glass ...

background: the present study aimed to determine the prevalence and associated risk factors of vaginal trichomoniasis in women referred to gynecologic clinic in benha university hospital, egypt. methods: two hundred female patients enrolled in the study. vaginal samples were obtained from them and examined for t. vaginalis by wet mount, giemsa stain, acridine orange (ao) stain and culture on mo...

The glass transition is investigated in three dimensions for single and double Yukawa potentials for the full range of control parameters. For vanishing screening parameter, the limit of the one-component plasma is obtained; for large screening parameters and high coupling strengths, the glass-transition properties cross over to the hard-sphere system. Between the two limits, the entire transit...

Microfluidic devices can perform multiple laboratory functions on a single, compact, and fully integrated chip. However, fabrication of microfluidic devices is difficult, and current methods, such as glass-etching or soft-lithography in PDMS, are either expensive or yield devices with poor chemical robustness. We introduce a simple method that combines the simple fabrication of PDMS with superi...

Nematode specimens for taxonomical work generally are mounted permanently in glycerol between two coverslips in a Cobbs aluminum slide or on a glass slide under a thin coverslip. In both cases, glass fibers of suitable diameter are used to keep the coverslip from pressing on the specimens. For larger nematodes, pieces of nickel-chrome wire can be used instead of the glass fibers (1). These type...

Introduction No dental material meets all requirements to be considered as an ideal restorative material should meet all the requirements, and should be biocompatible and non-toxic to the tissues. Biomaterials 1993;14: 906–16]. Most of these materials have to contact or interact with body tissue and fluids, so material’s selection must take into consideration not only mechanical and physical pr...

We have developed a wedge-loaded double-cantilever beam adhesion measurement set-up for thin films deposited on glass by sputtering. The test is described in details. Results on the Glass/sublayer/Ag/ZnO multilayer provide evidence that SnO2 or TiO2 perform better than ZnO as a sublayer. Then however, rupture within the multilayer shifts to the upper Ag/ZnO interface. The latter is shown to be ...

We report a general approach to the design of broadband waveguide couplers. A double-parallel grating assembly is used to cancel the first chromatic order, and a proper choice of prism glass and base angle is made to compensate for the second chromatic order. The technique was applied to a Corning glass 7059 waveguide, and a spectral bandwidth of 70 nm was measured by the use of two complementa...