in methods presented to calculate the voltage collapse point, the transmission system is usually the only part of the power system that is completely modeled. distribution systems are often replaced by aggregate load models because the use of the detailed model of distribution systems in voltage stability analysis not only increases the computation time, but also decreases the probability of co...

The rapid progress of semiconductor technologies enables the integration of huge amount of transistors on the same chip but creates new problems for digital and analog designers. The very high speed of operation allows millimeterwave CMOS circuits but various limits challenge the analog designer that must find new solutions. Key limits are the intrinsic gain of MOS transistors, the gate leakage...

Small form-factor piezoresistive MEMS sensors, often configured in a Wheatstone bridge, are widely used to measure physical signals such as pressure [1-3], temperature [4], force [1], and gas concentration. A common method to realize a digital output from the bridge involves biasing the bridge with a DC voltage source and using a low-noise amplifier followed by an ADC. While a bridge measuremen...

Estimation of collapse performance is primarily conducted through Collapse Fragility Curves (CFC’s). The EDP-based approach is the main scheme for attaining such curves and employs IDA. Obtaining CFC’s from IDA results is tremendously time consuming and computationally demanding. Introduction of more efficient methods of seismic analysis, can potentially improve this issue. The Endurance Time (...

The performance of a chaotic micro resonator is improved by redesigning a quadratic controller reported in a previous study. The chaotic micro resonator is composed of an electrostatic actuator and a voltage regulator (controller). The actuator is made of cantilever beam electrode above a fixed electrode. The actuator voltage, and consequently the electrostatic force magnitude, is controlled to...

The time-harmonic eddy current problem with either voltage or current intensity excitation is considered. We propose and analyze a new finite element approximation of the problem, based on a weak formulation where the main unknowns are the electric field in the conductor, a scalar magnetic potential in the insulator and, for the voltage excitation problem, the current intensity. The finite elem...

Increased functionality and performance demands are challenging System-on-Chip (SoC) designers to seek better methods for optimizing available battery power in portable applications. Key areas of exploration include dynamic voltage scaling and improved software algorithms for the control of power modes. Dynamic voltage scaling can be improved by adaptively monitoring hardware performance to min...

This paper proposes a novel approach for coherent generators online clustering in a large power system following a wide area disturbance. An interconnected power system may become unstable due to severe contingency when it is operated close to the stability boundaries. Hence, the bulk power system controlled islanding is the last resort to prevent catastrophic cascading outages and wide area bl...