An important problem in metallurgy of iron and steel is management of hydrated, fine-grained, iron-bearing waste which can be formed as a result of gas scrubbing. The article presents a model of application of converter slurry in a closed-circuit flow system. The correct preparation of slag, namely briquetting with defined additives, allows for application of such slag in the steel-making proce...

An attempt made to optimize the operating parameters involved in an autogenous pulsed Nd: YAG laser welding process of similar and dissimilar combinations of butt joint of 2 mm thick 316 L stainless steel and mild steel. Influence of prominent laser welding parameters such as average peak power, defocus position, spot position, and shielding gas were investigated for welded joints considered. T...

in this study, the effects cold rolling and annealing parameters during thermomechanical processing of the aisi 201ln stainless steel were investigated. the cast samples were homogenized, hot-rolled and solution-annealed to acquire a suitable microstructure for the subsequent thermomechanical treatment. unidirectional and transverse multi-pass cold rolling at 25, 0 and -15 °c was carried out to...

Flexible intramedullary nails are commonly used to treat femoral fractures in children. This study evaluated the biomechanical differences between stainless steel and titanium nails when securing transverse and comminuted fractures in a synthetic femur model. Retrograde flexible stainless steel and titanium nails placed in a divergent "C" pattern were mechanically tested, and axial rotation and...

This paper presents a study to evaluate the mechanical properties of commercially available GRP composite fasteners for the fairing band assembly components of the hull mounted sonar domes on Canadian frigates. The study was undertaken as part of an effort to develop an all-composite fairing band assembly for a stainless steel sonar dome, to eliminate corrosion problems that occur with the use ...

Initiation of corrosion on reinforcing bars occurs when a critical chloride concentration is achieved. A universal value for the chloride concentration that causes depassivation has not been agreed upon for carbon steels due to a variety of experimental factors. The chloride threshold depends on the rebar material, rebar surface condition, testing environment, method of detection, definition of...

Introduction: During sliding mechanics, frictional resistance is an important counterforce to orthodontic tooth movement; which must be controlled to allow application of light continuous forces. objective: To investigate static and kinetic frictional resistance between three orthodontic brackets: ceramic, self-ligating, and stainless steel, and three 0.019×0.025” archwires: stainless steel, ni...

A self-developed rotary multi-cutter device cuts stainless steel wire ropes into segments to fabricate twisted wires. Stainless steel porous twisted wire materials (PTWMs) with a spatial composite intertexture structure are produced by the compaction and subsequent vacuum solid-phase sintering of twisted wires. The stainless steel PTWMs show two types of typical uniaxial tensile failure modes, ...

Nuclear energy provides more than 10% of electrical power internationally, and the increasing engagement of nuclear energy is essential to meet the rapid worldwide increase in energy demand. A paramount challenge in the development of advanced nuclear reactors is the discovery of advanced structural materials that can endure extreme environments, such as severe neutron irradiation damage at hig...

The effect of microstructural refinement and intercritical annealing on the mechanical properties and work-hardening response of a low carbon St12 steel was studied. It was revealed that intercritical annealing of the ferritic-pearlitic sheet results in the formation of a coarse-grained DP microstructure with discrete martensite islands normally formed in place of pearlitic colonies, which resu...