introduction: the resistance to fracture of endodontically treated teeth restored with esthetic post systems has not been extensively researched. this in vitro study compared the fracture patterns of endodontically treated teeth with esthetic post systems with different analysis methods. materials and methods: a total of 26 recently extracted human maxillary central incisors were decoronated an...

a non-linear finite element model could be a useful tool in the development of a method of predicting soil pressure-sinkage behaviour, and can be used to investigate and analyze soil compaction. this study was undertaken to emphasize that the finite element method (fem) is a proper technique to model soil pressure-sinkage behaviour. for this purpose, the finite element method was used to model ...

in this paper the critical strain energy release rate for t300/913 carbon-epoxy laminated composites has been studied using ansys finite element software based on virtual crack closure technique ( vcct ). compact tension ( ct ) specimen has been used for numerical analyses and the geometrical dimensions have been extracted from the existing references. the results obtained from the finite eleme...

three dimensioned finite element analysis were conducted on concrete block paving. in order to verify the calculated results, an experimental case study was analyzed. good agreement was observed between the measured and the calculated results. based on the finite element analysis results and available failure models, comprehensive design charts were developed for port and industrial pavement wh...

The fundamental frequencies and mode shapes of steel and carbon fiber–reinforced plastic (CFRP) cylindrical shells with steel inserts were investigated using finite element analysis and modal testing. The free-free boundary condition was tested with modal testing using the roving hammer method and verified by finite element analysis using ABAQUS. The results show good agreement between the test...

This research introduces an advanced forging method to produce the door frame of the wind turbine tower. The advantage of the new forging method is the increase of raw material utilization ratio and the energy saving. In the conventional method, the door frame is hot forged with a hydraulic press and machined out lots of material because of the big difference between forging shape and final mac...

the aim of this study was to determine the effect of trenched zirconia bar on the von mises stress distribution of ips -empress ii core ceramics.the three-dimensional model including a three-unit bridge from the second premolar to the second molar was designed. the model was reinforced with zirconia bar (zb), zirconia bar with vertical trench (vzb) and zirconia bar with horizontal trench (hzb) ...

an interface part is used between clutch pedal and clutch cable in peugeot, samand, rd and peugeot pars. this part is consisted of two pieces. the main body is made of polyamide 6.6 and the second part is made of ck45.due to the fact that the two pieces are made of different assembling geometry with respect to each other, therefore, has caused performance problems which may result in clutch cab...